parts catalog

ENGINE AR-PRIM 5088595 - Caterpillar

5088595 ENGINE AR-PRIM Caterpillar parts ENGINE
Alternative (cross code) number:
Caterpillar 5088595 ENGINE AR-PRIM

Buy ENGINE AR-PRIM 5088595 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


This Special Instruction provides the procedure for troubleshooting poor air conditioner performance due to leakage through the water valve. Any coolant that is leaking through the valve allows continuous output from the heater. This also affects the air conditioner's ability to cool. This procedure will help the technician to determine if the valve is operating properly.Troubleshooting Procedure
Illustration 1 g01515211
(A) 206-1682 Control Panel (B) 189-0881 Control
Remove control panel (A) with control (B) from the 206-1700 Operator Console Gp (RH). See Illustration 1.Note: Use caution as you remove control panel (A) in order to prevent damage to the attached wiring.
Illustration 2 g01515212
(B) 189-0881 Control (C) 193-3356 Cable As
Disconnect cable assembly (C) from control (B) by removing the wire loop from the pin on the lever arm. See Illustration 2.
Illustration 3 g01515280
Rotate the temperature control knob to the fully counterclockwise position. This is the maximum cold position. See Illustration 3.
Illustration 4 g01515293
Pull the inner wire of the cable assembly toward the pin on the lever arm. The wire loop should be short of fitting on the pin on the lever arm by 3 mm (0.19 inch) to 5 mm (0.20 inch), as shown. See Illustration 4.Note: This gap ensures that the water valve is completely closed when the temperature control knob is positioned at the maximum cold position. If the gap between the wire loop and the pin is not 3 mm (0.19 inch) to 5 mm (0.20 inch), remove the clamp (D) on controller (B) and adjust the position of cable housing (C) to a gap of 3 mm (0.19 inch) to 5 mm (0.20 inch). Then, reinstall clamp (D). Refer to Illustration 5.
Illustration 5 g01515213
(A) 206-1682 Control Panel (B) 189-0881 Control (C) 193-3356 Cable As (D) 129-1831 Clamp
Rotate the temperature control clockwise so that the wire loop can be installed on the pin.
Reinstall control panel (A) back into the 206-1700 Operator Console Gp (RH) .Note: If it was necessary for you to adjust the cable, identify the 193-3356 Cable As as the part that is causing failure.

Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.