AVSPARE.COM
parts catalog

FILM-LUB CHART 3157227 - Caterpillar



3157227 FILM-LUB CHART Caterpillar parts FILM
Rating:
41
Alternative (cross code) number:
CA3157227
315-7227
3157227
Caterpillar 3157227 FILM-LUB CHART

Buy FILM-LUB CHART 3157227 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 21 g02576858
Move right screed extend switch (8) to the EXTEND position. Release the switch when the right screed extender is fully extended.
Move left screed extend switch (7) to the EXTEND position. Release the switch when the left screed extender is fully extended.
Illustration 22 g02576880
Move throttle control switch (9) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 23 g02576901
After the engine reaches low idle, move engine start switch (10) to the OFF position.
Move engine start switch (10) to the ON position. Do not start the engine.
Illustration 24 g02576976
Press home key (11) .
Illustration 25 g02568302
Press down key (12) until "Service" is highlighted on the display screen.
Press OK key (13) .
Illustration 26 g02568305
Press down key (12) until "Calibrations" is highlighted on the display screen.
Press OK key (13) .
Illustration 27 g02580480
Press down key (12) until "Right Paddle Sensor" is highlighted on the display screen.
Press OK key (13) .
Illustration 28 g02580496
Press OK key (13) to begin the calibration.
Illustration 29 g02580500
Make sure the conditions stated on the display are met, and then press OK key (10) .
Illustration 30 g02580516
Illustration 31 g02580518
Hold right paddle (14) in the full OFF position at approximately 45 degrees. Press OK key (13) .
Illustration 32 g02580520
Illustration 33 g02580525
Place right paddle (14) in the full ON position (straight down). Press OK key (13) .
Illustration 34 g02580526
The display should now read "CALIBRATION COMPLETE". Push back key (15) to return to calibration screen.
Push home key (11) to exit the calibration screen.
Move engine start switch (10) to the OFF position.


Parts film Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.