3843748 FILM-CAT Caterpillar parts
Rating:
Alternative (cross code) number:
CA3843748
384-3748
3843748
CA3843748
384-3748
3843748
Weight: 0.60 pounds 0 kg.
For full view, you need register
Information:
Disclaimer
Caterpillar disclaims any and all liability for use of third-party application software that will be used to control the Automatic Transfer Switches.
Automatic Transfer Switches are often used in critical applications. Failure of an Automatic Transfer Switch to operate properly could cause property damage, personal injury or death. Extreme caution must be used when designing or using programming software that will communicate with the Automatic Transfer Switch. Improper use of the Modbus network variables will cause the Automatic Transfer Switch to malfunction. Always conduct a full test and debug of the programming software prior to installing and using it in the system.
ZNET100
Illustration 1 g00839984
The ZNET100 network card enables the communication of the following information: the position of the transfer switch, the sources that are available, the timers that are running and the test that is running. The information is sent to a remote annunciator panel, a PC, or a PLC via one pair of twisted wires. The wires should be 16 AWG. This cable is not included. The connections are located below the relay for the engine start timer.
Caterpillar disclaims any and all liability for use of third-party application software that will be used to control the Automatic Transfer Switches.
Automatic Transfer Switches are often used in critical applications. Failure of an Automatic Transfer Switch to operate properly could cause property damage, personal injury or death. Extreme caution must be used when designing or using programming software that will communicate with the Automatic Transfer Switch. Improper use of the Modbus network variables will cause the Automatic Transfer Switch to malfunction. Always conduct a full test and debug of the programming software prior to installing and using it in the system.
ZNET100
Illustration 1 g00839984
The ZNET100 network card enables the communication of the following information: the position of the transfer switch, the sources that are available, the timers that are running and the test that is running. The information is sent to a remote annunciator panel, a PC, or a PLC via one pair of twisted wires. The wires should be 16 AWG. This cable is not included. The connections are located below the relay for the engine start timer.