AVSPARE.COM
parts catalog

FRAME AS 2277898 - Caterpillar



2277898 FRAME AS Caterpillar parts FRAME
Rating:
11
Alternative (cross code) number:
CA2277898
227-7898
2277898
Caterpillar 2277898 FRAME AS

Buy FRAME AS 2277898 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Stopping the Machine
Be sure the parking brake is applied and holding the machine before leaving the cab.Always block wheels securely before leaving the machine.
Stop the machine on level ground. Do not stop the engine at this time.
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components. Follow the "Stopping the Engine" procedure, outlined below, to allow the engine to cool and to prevent excessive temperatures in the turbocharger centerhousing which will cause oil coking problems.
1. Release accelerator (1) and depress service brake pedal (2) to stop the machine.2. Move transmission lever (3) to NEUTRAL, after the machine has stopped.3. Apply parking brake (4).Stopping the Engine
1. Run the engine at LOW IDLE for five minutes.2. Turn the engine start switch key to OFF to stop the engine.In an emergency, the ground level shutdown handle can be pulled. 3. Raise the levers up to drain condensate from the service brake/retarder, engine governor and the parking/secondary brake air reservoirs. After the tanks drain, return the levers to the DOWN position. 4. Drain the condensate from the air start reservoir. The air start tank should be drained with the engine running and allowed to refill prior to engine shutdown, unless an external air source is available to recharge the reservoir.If an external air source is used, drain the water from the external air source system, before recharging air start system.5. Turn the engine start switch key to OFF and remove the key. Turn off disconnect if machine will not be used for some time, or if machine will be serviced.6. If the machine is parked on a slope, block the wheels.7. Use the steps and handholds when dismounting.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.