FRAME AS 3967669 - Caterpillar

Illustration 49 g00835593
Remove Tooling (A) from the air cleaner support.
Illustration 50 g00835589
Tighten clamp (21) .
Illustration 51 g00835587
Connect tube assembly (20) .
Illustration 52 g00835578
Connect hose assembly (18) to the bottom of evaporator (17) .
Connect quick disconnect fitting (19) to the in-line dryer.
Illustration 53 g00835569
Install bolt (15), the washer, and the bracket.
Connect electrical connector (14) .
Illustration 54 g00835561
Install two wire ties (12) .
Connect hose assembly (13) .
Illustration 55 g00835557
Install bolt (11), the washer, and the clip.
Illustration 56 g00835497
Connect three hose assemblies (10) .
Illustration 57 g00835490
Carefully install precleaner assembly (9). Tighten clamp (8) .
Illustration 58 g00835487
Tighten clamp (7) .
Illustration 59 g00830173
Install guard (5). Install two nuts (6) and two washers.
Illustration 60 g00830167
Install two nuts (4) and two washers on guard (5) .
Illustration 61 g00830163
Install guard (2). Install two nuts (3) and two washers.
Illustration 62 g00830132
Install two bolts (1) and two washers on guard (2) .
Fill the cooling system. The capacity of the cooling system is 43 L (11.4 US gal). Refer to Operation and Maintenance Manual, SEBU7458.
Fill the transmission. The capacity of the transmission is 59 L (15.6 US gal). Refer to Operation and Maintenance Manual, SEBU7458.,, End By:
Install the vane pump (pilot and braking). Refer to Disassembly and AssemblyRENR4366, "Vane Pump (Pilot and Braking) - Install".
Install the center drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Center) - Install".
Install the rear drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rear) - Install".
Install the cab. Refer to Disassembly and AssemblyRENR4366, "Cab - Install".