parts catalog

FUEL LINES 0003110 - Caterpillar

0003110 FUEL LINES Caterpillar parts 950B FUEL
Alternative (cross code) number:
Caterpillar 0003110 FUEL LINES

Buy FUEL LINES 0003110 Caterpillar genuine, new aftermarket tractor parts with delivery

Compatible equipment models: 0003110:

WHEEL LOADER  950B   Caterpillar
  For full view, you need register


Removal Procedure
Start By:
Remove the V-Belt. Refer to Disassembly and Assembly, "V-Belts - Remove and Install" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g03328437
Typical example
Place temporary identification marks on all connections for the harness assembly.
Remove nut (1) and nuts (2) from the terminals on alternator (3).
Remove the harness assembly from alternator (3).
Illustration 2 g03326629
Typical example
Remove nut (12) (not shown) and washer (11) (not shown).
Remove bolt (7) (not shown) and washer (6) (not shown).
Support alternator (3) and remove bolt (8) from the alternator.
Remove alternator (3) from bracket (9).
If necessary, remove bolt (4) and remove adjusting link (5).
If necessary, follow Step 10.a through Step 10.b in order to remove bracket (9) from the cylinder block.
Remove bolts (10) from bracket (9).
Remove bracket (9) from the cylinder block. Installation Procedure
Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.
Illustration 3 g03326629
Typical example
If necessary, follow Step 2.a through Step 2.c in order to install bracket (9) to the cylinder block.
Position bracket (9) onto the cylinder block.
Install bolts (10) to bracket (9) hand tight.
Tighten bolts (10) to a torque of 25 N m (221 lb in).
If necessary, install adjusting link (5) and install bolt (4) finger tight.
Position alternator (3) onto bracket (9). Note: Support the weight of the alternator as the bolt is installed.
Install bolt (8), washer (11) (not shown) and nut (12) (not shown) finger tight.
Illustration 4 g03328437
Typical example
Connect the harness assembly to the terminals on alternator (3). Ensure that the harness assembly connections are correctly installed.
Install nuts (2) and nut (1).
Tighten nuts (2) and nut (1). Refer to Specifications, "Alternator and Regulator" for the correct information.
Install the V-Belt. Refer to Disassembly and Assembly, "V-Belts - Remove and Install" for the correct procedure .
Turn the battery disconnect switch to the ON position.

Caterpillar SIS machinery equipment:

Caterpillar SIS

Parts fuel Caterpillar catalog:

950B, 950B/950E, 963
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.