parts catalog

GASKET 0002543 - Caterpillar

0002543 GASKET Caterpillar parts GASKET
Alternative (cross code) number:
Caterpillar 0002543 GASKET

Buy GASKET 0002543 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 1 g01004979
Schematic of the Action LampTest Step 1. CHECK THE HARNESS FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the J1 and J2 machine harness connectors from the ECM.
Disconnect the machine harness from the monitor.
At the J2 machine harness connector, measure the resistance from the solenoid contact J2-9 (wire J848-BU) to all possible sources of ground.Expected Result:The resistance should be greater than 5000 ohms for each measurement. Results:
OK - The resistance is greater than 5000 ohms for each measurement. The machine harness is correct. The monitor has failed.Repair: Replace the monitor.STOP
NOT OK - The resistance is NOT correct. There is a short in the machine harness. The short is between signal contact J2-9 (wire J848-BU) and the circuit with the low resistance measurement.Repair: Repair the harness or replace the harness.STOP

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.