777693 GAUGE, HYD. OIL TEMPERATURE Caterpillar parts CB-414, CB-614 GAUGE
Alternative (cross code) number:
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Part Number     Description     Quantity
8T-5096     Dial Indicator Gp     1
Part Number     Description     Thickness
0.1778 mm (0.007 inch)
0.1270 mm (0.005 inch)
Illustration 1 g00893068
(1) Bolt (2) Bolt (3) Retainer
Before the differential is installed in the carrier, set the pinion end play. Tighten retainer (3) until the pinion end play is 0.0508 0.0254 mm (.002 .001 inch). Shims may need to be added or shims may need to be subtracted in order to get the proper end play.
Install the differential in the carrier and tighten bolts (2) to a torque of 135.6 N m (100 lb ft).
Illustration 2 g00887799
Differential and bevel gear (4) Nut (5) Bevel gear (6) Nut
Put the carrier in a position so that the centerline for the axle is vertical and bevel gear (5) is on the bottom.
Rotate nut (6) in order to adjust the backlash between bevel gear (5) and the pinion. The backlash must be 0.3048 + 0.1270 - 0.1016 mm (0.012 + 0.005 - 0.004 inch). Adjust nut (4) in order to remove any end play while you adjust nut (6) .
Tighten nut (4) in order to make sure that the bearing cones are against the seats. Release the tension from nut (4). Finger tighten nut (4) in order to remove end play from the assembly.
Use a dial indicator in order to obtain the correct bearing preload. Measure the amount of change in dimension (A) as you tighten nut (4). Dimension (A) must change by 0.1778 0.0508 mm (.007 .002 inch). Install the nut locks.
Tighten four bolts (1) to a torque of 440.6 33.9 N m (325 25 lb ft). Install wires.
Turn the differential in the carrier. Check the backlash between the bevel gear and the pinion.