GEAR GP-FRONT 1246818 - Caterpillar

SNMPv1
Path: Administration > Network > SNMPv1 > options
Table 3
Option    Description    
access     "Enable SNMPv1 Access" : Enables SNMP version 1 as a method of communication with this device.    
access control     You can configure up to four access control entries to specify which Network Management Systems (NMSs) have access to this device. The opening page for access control, by default, assigns one entry to each of the four available SNMPv1 communities, but you can edit these settings to apply more than one entry to any community to grant access by several specific IPv4 and IPv6 addresses, host names, or IP address masks. To edit the access control settings for a community, click the community name.
- If you leave the default access control entry unchanged for a community, that community has access to this device from any location on the network.
- If you configure multiple access control entries for one community name, the limit of four entries requires that one or more of the other communities must have no access control entry. If no access control entry is listed for a community, that community has no access to this device.
"Community Name" : The name that an NMS must use to access the community. The maximum length is 15 ASCII characters, and the default community names for the four communities are public, private, public2, and private2.
"NMS IP/Host Name" : The IPv4 or IPv6 address, IP address mask, or host name that controls access by NMSs. A host name or a specific IP address (such as 149.225.12.1) allows access only by the NMS at that location. IP addresses that contain 255 restrict access as follows:
- 149.225.12.255: Access only by an NMS on the 149.225.12 segment.
- 149.225.255.255: Access only by an NMS on the 149.225 segment.
- 149.255.255.255: Access only by an NMS on the 149 segment.
- 0.0.0.0 (the default setting) which can also be expressed as 255.255.255.255: Access by any NMS on any segment.
"Access Type" : The actions an NMS can perform through the community.
"Read" : GETS only, at any time
"Write" : GETS at any time, and SETS when no user is logged onto the "Web interface" or "command line" interface.
"Write+" : GETS and SETS at any time.
"Disable" : No GETS or SETS at any time.    SNMPv3
Path: Administration > Network > SNMPv3 > options
For SNMP GETs, SETs, and trap receivers, SNMPv3 uses a system of user profiles to identify users. An SNMPv3 user must have a user profile assigned in the MIB software program to perform GETs and SETs, browse the MIB, and receive traps.Note: To use SNMPv3, you must have a MIB program that supports SNMPv3. The NMC supports SHA or MD5 authentication and AES or DES encryption.
Table 4
Option    Description    
access     "SNMPv3 Access" : Enables SNMPv3 as a method of communication with this device.    
user profiles     By default, lists the settings of four user profiles, configured with the user names " snmp profile1" through " snmp profile4", and no authentication and no