AVSPARE.COM
parts catalog

Gears, matched set 70000204 - Caterpillar



70000204 Gears, matched set Caterpillar parts Gears
Rating:
84
Alternative (cross code) number:
CA70000204
7000-0204
70000204
Caterpillar 70000204 Gears, matched set

Buy Gears, matched set 70000204 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 13
 
  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is associated with system voltage of the electrical system.This diagnostic code is recorded when the all wheel drive ECM reads the electrical system voltage that is at contact J1-1 as being below normal range (less than 18 volts for two seconds).The possible causes of this diagnostic code are listed:
A charging system component has failed.
The ECM has failed. This is unlikely.This diagnostic code causes the all wheel drive system to be inactive.Ensure that CID 0168 FMI F01 is on hold. The "SERV CODE" indicator is illuminated.Test Step 1. CHECK THE BATTERY VOLTAGE.
Measure the voltage at the battery posts.Expected Result:The voltage should be greater than 18 DCV.Results:
YES - The voltage is greater than 18 DCV. This should not cause the diagnostic code. Proceed to test step 2.
NO - The voltage is less than 18 DCV. The charging system is not correct. Repair: Check the charging system. See Special Instruction, REHS0354, "Charging System Troubleshooting". Stop.Test Step 2. CHECK THE SYSTEM VOLTAGE
Disconnect the machine harness from the ECM.
Turn the disconnect switch and the key start switch to the ON position.
At machine harness connector J1 for the ECM, measure the voltage between contact J1-1 and contact J1-2.Expected Result:The voltage should be greater than 18 DCV.Results:
YES - The voltage is greater 18 DCV. This should not cause the diagnostic code. Repair: Inspect connector J1. Connect the machine harness to the ECM. If the CID 0168 FMI F01 remains present, check the charging system. See Special Instruction, REHS0354, "Charging System Troubleshooting". If the cause of the diagnostic code is not found, replace the all wheel drive ECM. See Testing And Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NO - The voltage is less than 18 DCV. The machine harness has failed. Repair: Check the +battery circuit and the ground circuit in the machine harness. Repair the machine harness or replace the machine harness. Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
CP-323 VIBRATORY COMPACTOR 6JD00001-00065 (MACHINE) POWERED BY 4219D ENGINE


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.