AVSPARE.COM
parts catalog

GENERATOR GP 2277900 - Caterpillar



2277900 GENERATOR GP Caterpillar parts GENERATOR
Rating:
21
Alternative (cross code) number:
CA2277900
227-7900
2277900
Caterpillar 2277900 GENERATOR GP

Buy GENERATOR GP 2277900 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Check the fuel level with the fuel tank sight gauge on the tank side. Drain the water and sediment from the fuel tank at the start of a shift or after the fuel tank has been filled and allowed to stand for 5 to 10 minutes. After changing the fuel filters, always prime the fuel system to remove air bubbles from the system.Drain water and sediment from any fuel storage tank weekly, and before the tank is refilled. This will help prevent water or sediment being pumped from the storage tank into the machine fuel tank.Use only fuel as recommended in the "Coolant, Fuel and Lubricant Specifications" section of this guide.Hydraulic System
Make-up oil added to the hydraulic tank must mix with the oil already in the system. Use only petroleum products unless the system is equipped for use with special products.If the hydraulic oil becomes cloudy, water or air is entering the system. Water or air in the system will cause pump failure. Drain the fluid, retighten hydraulic suction line clamps, purge and refill the system. Consult your Caterpillar dealer for purging instructions.
Air Inlet System
If the indicator shows red shortly after installing a cleaned primary element, install another clean element, or a new element. The primary element can be cleaned up to six times before replacement. The element, when cleaned, should be thoroughly checked for rips or tears in the filter material. Replace primary element every year, even if it has not been cleaned six times. The secondary filter element should be replaced at the time the primary filter element is serviced for the third time.If the indicator shows red after installation of a clean primary element, or if the exhaust smoke is black, install a new secondary element.
Do not try to reuse the secondary element by cleaning it. Always use a new element.
Electrical System
Always wear eye protection. Do not smoke or use any equipment which gives off sparks or heat in the area around the batteries. Hydrogen is given off by the batteries during the charging operation. Hydrogen, mixed with air can explode.Never let the ends of the two cables make contact with each other.
When charging the machine batteries, follow the instructions in the Operation Section to properly charge the machine batteries.When using external electrical source to charge the machine battery, turn the disconnect switch off and remove the key before attaching the cables.
Scheduled Oil Sampling (S O S)
Use Scheduled Oil Sampling (S O S) to monitor machine condition and maintenance requirements. Each oil sample should be taken when the oil is hot and well mixed, to ensure that the sample is representative of the oil in the compartment. Consult your Caterpillar dealer for complete information and assistance in establishing a Scheduled Oil Sampling program for your equipment.General
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water every 1000 hours, or each time any significant quantity of oil is spilled on a machine.
1 kilopascal (kPa) is


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.