1695304 GRAPPLE AR-MECHANICAL Caterpillar parts G112 GRAPPLE
Alternative (cross code) number:
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Compatible equipment models: 1695304:
GRAPPLE-MECHANICAL G112 Caterpillar
Illustration 1 g00850901
Test Step 1. Check for Connector Damage.
Turn the circuit breaker for the battery to the OFF position.
Turn the Start/Stop Switch to the STOP position.
Thoroughly inspect the ECM connectors J1/P1 and J2/P2. Inspect all of the other connectors. Refer to Troubleshooting, "Inspecting Electrical Connectors" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the circuit.
Check the ECM connector (allen head screw) for the proper torque of 6.0 N m (55 lb in).
Check the customer connector (allen head screw) for the proper torque of 2.25 0.25 N m (20 2 lb in).
Check the harness and the wiring for abrasion and pinch points.Expected Result:The wiring and connectors should be free of the following problems: damage, abrasion, corrosion and incorrect attachment.Results:
OK - The connectors and wiring are okay. Proceed to test step 2.
Not OK - The connectors and/or wiring need repair.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Stop.Test Step 2. Inspect the Throttle Assembly.
The throttle assembly should be free of the following problems: loose parts, bent parts, broken parts, missing parts and worn parts.Expected Result:The throttle assembly should operate smoothly without excessive drag. The throttle should return to the low idle position without assistance in less than one second.Results:
OK - The throttle assembly functions properly. Proceed to test step 3.
Not OK - The throttle assembly is not operating correctly.Repair: Repair the throttle assembly or replace the throttle assembly. The throttle assembly should operate smoothly without excessive drag. The throttle assembly should return to the low idle position without assistance in less than one second. Stop.Test Step 3. Check the Throttle Position with the ET.
Connect the ET to the service tool connector.
Connect the main power.
Observe the Throttle Position reading on the Electronic Service Tool Status screen.
Move the throttle to low idle. Slowly move the throttle toward the highest engine speed setting. Monitor the status screen.Expected Result:The Throttle Position should read 0.0 percent when the throttle is in the low idle position. The Throttle Position should move to 100 percent at the highest engine speed setting.Results:
OK - The Throttle Position reads 0.0 percent when the throttle is in the low idle position. The Throttle Position moves to 100 percent at the highest engine speed setting.Repair: There may be an intermittent problem. If the problem is intermittent refer to Troubleshooting, "Inspecting Electrical Connectors". Stop.
Not OK - The Throttle Position does not read 0.0 percent when the throttle is in the low idle position. The Throttle Position does not move to 100 percent at the highest engine speed setting. Proceed to test step 4.Test Step 4. Check the Throttle Position Signal and the Duty Cycle at the ECM.
Connect the main power.
Measure the frequency and the duty cycle between wire F702-GN in P2-24 and the digital return P1-29 of ECM connector J1/P1.Note: Set the multimeter to "VDC". Press the "Hz" button twice so that the % symbol is displayed.
Monitor the duty cycle with the multimeter. Monitor
Caterpillar SIS machinery equipment:
Caterpillar parts catalog:
Parts grapple Caterpillar catalog:
1773821 GRAPPLE GP
1694407 GRAPPLE GP
1694421 GRAPPLE GP