GUIDE AS.-HOSE 1246359 - Caterpillar

SMCS Code: 5705Implements and Swing Controls
Illustration 6The machine control pattern can be varied by changing the hydraulic hose connections. Consult your Caterpillar dealer for the procedure.
Illustration 7The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left control lever and the pattern on the right pertains to the right control lever.
Stick Out (1)-Move the control lever to this position in order to move the stick out.
Swing Right (2)-Move the control lever to this position in order to swing the upper structure to the right.
Stick In (3)-Move the control lever to this position in order to move the stick in.
Swing Left (4)-Move the control lever to this position in order to swing the upper structure to the left.
Boom Lower (5)-Move the control lever to this position in order to lower the boom.
Bucket Dump (6)-Move the control lever to this position in order to dump the bucket.
Boom Raise (7)-Move the control lever to this position in order to raise the boom.
Bucket Close (8)-Move the control lever to this position in order to close the bucket. Hold (9)-When you release the control levers from any position, the control levers will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a control lever diagonally.Front Shovel Configuration (If Equipped)
Illustration 8The machine control pattern can be varied by changing the hydraulic hose connections. Consult your Caterpillar dealer for the procedure.The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left control lever and the pattern on the right pertains to the right control lever.
Stick Out (1)-Move the control lever to this position in order to move the stick outward.
Swing Right (2)-Move the control lever to this position in order to swing the upper structure to the right.
Stick In (3)-Move the control lever to this position in order to move the stick inward.
Swing Left (4)-Move the control lever to this position in order to swing the structure to the left.
Boom Lower (5)-Move the control lever to this position in order to lower the boom.
Bucket Dump (6)-Move the control lever to this position in order to dump the bucket.
Boom Raise (7)-Move the control lever to this position in order to raise the boom.
Bucket Close (8)-Move the control lever to this position in order to close the bucket. Hold (9)- When you release the control levers from any position, the control levers will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a control lever diagonally.Tool Lowering Check Valve (U-Linkage (If Equipped))
Illustration 9The Tool Lowering Check Valve is located on the linkage cylinder. Turn the lever as shown in the illustration 9 in order to obtain the appropriate application. Tool Application (1)- Place the lever in that position in order to work