HANDLE 1247436 - Caterpillar

Illustration 1 g03379718
(1) Keypad guidance area
(2) Back Button
(3) "OK" Button
(4) Left key
(5) Up key
(6) Down key
(7) Right keyThe menu option is entered by selecting "Configurations" from the Service menu. To select this option, press the Up key (5) or the Down key (6) until "Configurations" is highlighted. Then press the "OK" Button (3).Note: Refer to Systems Operation, "Service Mode" for instructions to get to the Service menu.The following is a list of configurations that can be performed with the monitoring system:
ECM Identification
Work Mode
Machine Attachments
Travel Speed Shift
Throttle Dial Speed
Throttle Dial Hydraulic Power
Recommended Interval
Security Access
Cat® Grade Control System
Auxiliary Hydraulic Attachment
Control Inputs
Crane System
Front Control
Hydraulic Cab Riser
Fan Configuration
Camera InputsVideo Mode Setting if Equipped
From the Configurations menu, use the appropriate Up or Down key to highlight the "Video Mode Setting" menu. Then press the "OK" button.The monitoring system can display the camera image on the monitor by selecting the "Switch Panel Module".Depending on whether a camera is installed, the monitor can display two different views.The configuration of a camera status installation can only be changed by a service technician.
Illustration 2 g03575438Video Mode Setting Glossary
The following descriptions are items the user can change and adjust.VIDEO MODE - When the Video Mode is ON, "ON" or "OFF" can be chosen and the camera image can be displayed.ANGLE ADJUST - Allows the operator to change the angle of the camera.TINT - Allows the operator to change the pigment of the camera image. The pigment can be set from 0 to 15.COLOR - Allows the operator to change the color of the camera image. The color can be set from 0 to 15.CONTRAST - Allows the operator to change the contrast of the camera image. The contrast can be set from 1 to 15.BRIGHTNESS - Allows the operator to change the brightness of the camera image when the light is OFF. The brightness can be set from 0 to 22. As the number selected is incremented, the monitor will become brighter.Setup and Configuration of Additional Cameras
Harness Setup
Illustration 3 g03331826The 300F monitor can be configured for one, two, or three cameras. When installing an additional camera, connect the camera cable to the CN-2 connector of the 300F monitor.To configure an additional camera as Video 2, connect the camera cable to pin 3 (Video 2 +) and pin 4 (Video 2 -) of the CN-2 connector.To configure an additional camera as Video 3, connect the camera cable to pin 5 (Video 3 +) and pin 6 (Video 3 -) of the CN-2 connector.Monitor Setup
To display the additional camera image on the default screen, set up two screens.Configuration of Camera Inputs
Illustration 4 g03575456
Move to the following screen:
Main Menu >