AVSPARE.COM
parts catalog

HARDWARE GP 4646053 - Caterpillar



4646053 HARDWARE GP Caterpillar parts HARDWARE
Rating:
76
Alternative (cross code) number:
CA4646053
464-6053
4646053
Caterpillar 4646053 HARDWARE GP

Buy HARDWARE GP 4646053 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Never look into a laser beam or point the beam into the eyes of other people. Set the laser at a height that prevents the beam from flashing directly into people's eyes.
Set up the laser transmitter so the laser beam is at a zero percent grade and a zero percent cross slope. Refer to the Operation and Maintenance Manual for the laser transmitter instructions on setting the grade and cross slope.Note: Caterpillar recommends the use of a laser transmitter with the following features: automatic self-leveling mode, 600 rpm min rotational speed and automatic out of level shutoff. Read the operator manual and follow the operator manual that is supplied with the laser transmitter. The tripod and the laser should be located at least 46 m (150 ft) away from the machine. The laser should be located in an area so that the laser will not detect reflections or any light source that could disrupt the laser. Set the height of the tripod and the laser transmitter so that the laser beam will strike the laser receiver when the receiver is positioned correctly on the machine. Set the laser high enough so that the cab of the machine will not stop the laser beam from being detected by the laser receiver.
Ensure that the masts are at the lower limit.Note: Keep the height of the laser receivers as low as possible. This will help ensure greater system accuracy during calibration of the AccuGrade - Laser System.
Crushing hazard! Read and understand the instructions and warnings in the Operation and Maintenance manual. Failure to follow the instructions or heed the warnings could cause serious injury or death.
Raise the blade approximately 30 cm (12 inch). Ensure that there is enough room in order to use a level under the edge of the blade.
Place blocks under the blade before checking the blade level.
Illustration 1 g01099045
Level the blade. Use a level in order to be sure that the bottom of the blade's cutting edge is level.
Press the Menu key (6) .
Illustration 2 g01311325
Perform the following procedure in order to enter the "Installation" menu. Refer to Illustration 2. You must perform the functions simultaneously in the order as listed below.
Press and hold down the "ESC/left reset" key (A) .
Press and hold the right down Arrow Key (B) .
Press and hold down the "Increment" key (C) .
Release all the keys simultaneously.This causes the "Installation" menu to be shown on the LCD of the display.
Press the Arrow Keys (1) until "Calibration" is highlighted on the display.
Illustration 3 g01305056
Press the "OK/left reset" key (8) in order to enter the "Calibration" menu.
Press the Arrow Keys (1) until "Linked Elevation Calibration" is highlighted on the display.
Illustration 4 g01311655
Press the "OK/left reset" key (8) in order to enter the "Linked Elevation Calibration" menu.
Illustration 5 g01305058
A


Parts hardware Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.