parts catalog

HARNESS AS-WIRING 3534832 - Caterpillar

3534832 HARNESS AS-WIRING Caterpillar parts HARNESS
Alternative (cross code) number:
Caterpillar 3534832 HARNESS AS-WIRING
Weight: 9 pounds 4 kg.

Buy HARNESS AS-WIRING 3534832 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 22
  For full view, you need register


Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00590713
Insert the shaft (2) into the housing (5) of the air choke.
Install the choke plate (4). When you install the choke plate leave the mounting bolts (1) loose. Install the thrust washer (3). Install the bolts. Tighten the bolts to a torque of 47 9 N m (35 7 lb ft). Fully close the choke plate. Tighten the mounting bolts for the choke plate to a torque of 12 3 N m (9 2 lb ft).
Install the plate and the two bolts. Tighten the two bolts to a torque of 47 9 N m (35 7 lb ft).
When the choke plate is assembled on the shaft, install the adjusting bolt until the adjusting bolt makes contact with the stop plate. The adjusting bolt should then be tightened an additional 90 degrees. Tighten the adjusting nut to a torque of 25 6 N m (18 5 lb ft). Note: Do not allow the set screw to turn while you tighten the locknut.End By:
Install the air choke.

Caterpillar parts catalog:

Caterpillar parts catalog
TH417C Telehandler RRJ00246-UP (MACHINE)

Parts harness Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.