parts catalog

HEAD, CYLINDER 7096530C1 - Caterpillar

7096530C1 HEAD, CYLINDER Caterpillar parts HEAD
Alternative (cross code) number:
Caterpillar 7096530C1 HEAD, CYLINDER

Buy HEAD, CYLINDER 7096530C1 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 8
  For full view, you need register


Table 1
Required Tools    
Part Number    Description    Qty    
8T-0859     Pressure Gauge (
25000 kPa (3625 psi))     1    
9U-7400     Multitach Tool Group     1    
Illustration 1 g00817309
Pump compartment (33) Fan pump (34) Pressure tap (35) Relief valve (fan pump)
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Position the machine on level ground.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing And Adjusting, "Hydraulic System Pressure - Release".
Install 9U-7400 Multitach Tool Group on the fan for the hydraulic oil cooler.
Start the engine.
Place the machine controls at the following settings: AEC switch OFF and engine speed dial "10".ReferenceRefer to Testing And Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Read the fan speed. Refer to Table 2 for the correct speed.
Table 2
Fan Speed    
1360 10 rpm (1)    
1730 10 rpm (2)    
( 1 ) Standard specification
( 2 ) High ambient specification
If the fan speed is not within the specification, adjust the relief valve for the fan pump.Adjust
Illustration 2 g00817311
Pump compartment (35) Relief valve (fan pump) (36) Locknut (37) Adjustment screw
In order to adjust the relief valve pressure setting for the fan pump, loosen locknut (36) and turn adjustment screw (37) .Note: Turning adjustment screw (37) clockwise increases the pressure. Turning adjustment screw (37) counterclockwise decreases the pressure.Note: A quarter turn of the relief valve changes the pressure approximately 3300 kPa (480 psi).Note: Always make final pressure adjustments on pressure rise.
Adjust the relief valve pressure to the specifications in Table 3.Note: In order to avoid hydraulic component damage, adjust the fan speed within the specifications in Table 3.
Table 3
Fan Speed    Relief Valve Pressure    
1360 10 rpm (1)    
8000 kPa (1160 psi)    
1730 10 rpm (2)    
12900 kPa (1870 psi)    
( 1 ) Standard specification
( 2 ) High ambient specification
Tighten locknut (36) to a torque of 9.8 0.6 N m (7 0.4 lb ft).

Caterpillar parts catalog:

Caterpillar parts catalog

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.