parts catalog

HITCH GP 5088789 - Caterpillar

5088789 HITCH GP Caterpillar parts HITCH
Alternative (cross code) number:
Caterpillar 5088789 HITCH GP

Buy HITCH GP 5088789 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
  For full view, you need register


Illustration 1 g01528649
Schematic of the Neutralizer SwitchThis diagnostic code is recorded when the ECM reads the signal voltage of the pressure switch as being too low. The possible causes of this diagnostic code are listed:
Wire (766-GN) is shorted to ground.
The switch has failed.
The ECM has failed. This is unlikely.Test Step 1. CHECK THE SWITCH.
Turn the disconnect switch and the key start switch to the ON position.
Ensure that the diagnostic code is active.
Observe the status of the diagnostic code. Disconnect the machine harness from the switch.Expected Result:The diagnostic code will remain active if the switch is not the cause of the problem. The switch is the cause of the problem if the diagnostic code is NO longer active.Results:
OK - The diagnostic code remains active. The switch has not failed. The machine harness may have failed or the ECM may have failed. Proceed to test step 2.
NOT OK - The diagnostic code is NO longer active.Repair: The machine harness and the ECM are operating properly. The switch has failed. Replace the switch.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT FOR A SHORT TO GROUND.
The switch remains disconnected from the machine harness.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector J1 and J2 from the ECM.
At the J1 machine harness connector, measure the resistance from contact J2-54 (wire 766-GN) to all source of ground.Expected Result: The resistance should be greater than 5 ohms. Results:
OK - The resistance is greater than 5 ohms. The machine harness is correct. Proceed to test step 3.
NOT OK - The resistance is less than 5 ohms.Repair: There is a short in the machine harness. The short is between the signal circuit (wire 766-GN) and the circuit with the low resistance measurement. Repair the machine harness or replace the machine harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Observe the status of the diagnostic code.
Operate the machine.
Observe the status of the diagnostic code.Expected Result:The diagnostic code is NO longer active.Results:
YES - The diagnostic code is NO longer active. The diagnostic code does not exist at this time. The initial diagnostic code was probably caused by a poor electrical connection and/or a short at one of the harness connectors that was disconnected and then reconnected. Resume normal machine operation.STOP
NO - The diagnostic code has not been corrected. The ECM has failed. Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this diagnostic code procedure again. Replace the ECM if the cause of the diagnostic code is not found. See Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP

Caterpillar SIS machinery equipment:

Caterpillar SIS

Parts hitch Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.