HOSE AS 1246379 - Caterpillar

Changing the Tamper System Status
Note: The Tamper system status can be changed in VisionLink only and cannot be changed from Cat ET.Status Definitions:Disable - Prevents engine start.Normal Operation - Machine performs as normal.
Illustration 18 g06268502
In VisionLink Administrator, click the "Manage Asset Configurations" link under the "Asset Settings" section.
Illustration 19 g06268507
Use the drop-down box to select the desired telematics device type.
Illustration 20 g06268513
Use the search bar to search for the desired asset. Click the check mark on the left-hand side of the asset icon to select the asset.
Illustration 21 g06268515
Click the triple dot icon in the upper right-hand side of the page and click "Configure".
Illustration 22 g06268517
Use the drop-down box to select "Asset Security".
Illustration 23 g06268542
Select "Disable" or "Normal Operation" under "Security Status" and click "Save".
Illustration 24 g06268545
The message in green above will appear to confirm that the command to disable or return to normal operation has been sent to the machine.Troubleshooting
Event Identifier Codes
Table 1
Event Identifier Codes
EID Description Cause
E1377 (1) Machine Disable Pending due to Machine Security Event becomes active 8 hours after signal is lost (Level 2 and 3).
E1377 (2) Machine Disable Pending due to Machine Security Event becomes active 24 hours after signal is lost (Level 2 and 3).
Event becomes active when the machine receives the remote disable command (Level 1, 2, and 3).
E1377 (3) Machine Disable Pending due to Machine Security Event becomes active 168 hours after signal is lost (Level 3). Diagnostic Trouble Codes
Table 2
Diagnostic Trouble Codes
DTC Description Procedure
1639–9 Machine Security System Module: Abnormal Update Rate Product Link ECM has been disconnected from the J1939 Datalink. Reconnect to clear code.
1888–3 Local GPS Antenna: Voltage Above Normal GPS antenna has been disconnected from the Product Link ECM. Reconnect to clear code.
4682–3 Cellular Antenna: Voltage Above Normal Cellular antenna has been disconnected from the Product Link ECM. Reconnect to clear code. Symptom Based Troubleshooting
Table 3
Symptom Procedure
Tamper Does Not Install - ET (Security System Tamper Resistant Configuration parameter will not change to the set level) If MSS is installed, verify that the machine supports both MSS and Tamper to be installed at the same time: If the machine supports Bluetooth Operator ID (Bluetooth key or Bluetooth mobile app) it will support both MSS and Tamper. If unsure, check the machine operation manual operator login section to see if Bluetooth entry is covered. If the machine does not support Bluetooth Operator ID, it will not support both MSS and Tamper.
Tamper Does Not Install - VisionLink (Security System Tamper Resistant Configuration parameter will not change to "Level 1" in ET) Verify that