AVSPARE.COM
parts catalog

HOSE AS 3078986 - Caterpillar



3078986 HOSE AS Caterpillar parts 307D, 308E CR, 308E SR, 320D FM HOSE
Rating:
26
Alternative (cross code) number:
CA3078986
307-8986
3078986
Caterpillar 3078986 HOSE AS
Weight: 1 pounds 0 kg.

Buy HOSE AS 3078986 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, MINI HYD EXCAVATOR,

Compatible equipment models: 3078986:

EXCAVATOR  320D FM  
MINI HYD EXCAVATOR  307D   308E CR   308E SR   Caterpillar
Number on catalog scheme: 6
 
  For full view, you need register

Information:


Illustration 1 g06071744
Wheel Lean Left Solenoid connections
This diagnostic code is associated with the "wheel lean left" solenoid. The FMI 05 means that the ECM has determined that the current for the solenoid circuit is below normal.The Implement ECM provides a PWM signal (output) to the solenoid to provide proportional control of the solenoid. The ECM will vary the electrical current of the PWM output signal based on the input command that is received from the "wheel lean control" position sensor that is located in the assembly of the "left joystick".Some possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This situation is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure, and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE SOLENOID
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire U747-OR(Orange)) to contact 2 (wire H862-GY(Grey)).
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the CID 2173 FMI 05 diagnostic code.Expected Result:The active diagnostic code changes from an FMI "05" diagnostic code to an FMI "06" diagnostic code when the jumper wire is installed.Results:
YES - The active diagnostic code changes from an FMI "05" diagnostic code to an FMI "06" diagnostic code when the jumper wire is installed. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 2173 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the diagnostic code. The solenoid is not the cause of the problem. Proceed to Test Step 2.Test Step 2. CHECK THE CIRCUIT FOR AN OPEN
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the ECM connector for the machine harness J1 from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector J1 for the ECM, measure the resistance from the return contact J1-55 (wire H862-GY(Grey)) to the energize contact J1-67 (wire U747-OR(Orange)).Expected Result:The measurement of the resistance is less

Caterpillar parts catalog:

Caterpillar parts catalog
307D Mini Hydraulic Excavator DSG00001-UP (MACHINE) POWERED BY 4M40 Engine
320D Forest Machines BZF00001-UP (MACHINE) POWERED BY C6.4 Engine
307D Mini Hydraulic Excavator WZX00001-UP (MACHINE)
308E CR Mini Hydraulic Excavator HEL00001-UP (MACHINE) POWERED BY C3.3B Engine
308E SR Mini Hydraulic Excavator JBE00001-UP (MACHINE) POWERED BY C3.3B Engine
308E CR Mini Hydraulic Excavator HAM00001-UP (MACHINE) POWERED BY C3.3B Engine
308E SR Mini Hydraulic Excavator JSN00001-UP (MACHINE) POWERED BY C3.3B Engine
320D2 FOREST MACHINE BW200001-UP (MACHINE) POWERED BY C7.1 Engine
320D2 LOG LOADER FOREST MACHINE CY200001-UP (MACHINE) POWERED BY C7.1 Engine


Parts hose Caterpillar catalog:

3057806 HOSE AS
307D, 307E, 308D, 308E
3132251 HOSE AS
307D, 308D, 308E CR, 308E SR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.