4415867 HOSE AS Caterpillar parts
Rating:
Alternative (cross code) number:
CA4415867
441-5867
4415867
CA4415867
441-5867
4415867
For full view, you need register
Information:
Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Bolt (1/2 inch - 20 NF by 4 inch) 2
B 138-7575 Link Bracket 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01148312
Typical example
Remove the two setscrews and install the Tooling (A) as guides. Note: The weight of the flywheel (2) is approximately 54 kg (119 lb). Install the Tooling (B) in order to support the flywheel (2) before the remainder of the setscrews (1) are removed.
Remove the remaining setscrews (1) that secure flywheel (2) to the crankshaft.
Remove the flywheel (2) from the engine.
Illustration 2 g01148313
Check the condition of the ring gear (4). Remove the ring gear (4) if the ring gear is worn or damaged. Note: Identify the orientation of the ring gear (4) on the flywheel (2) and the position of the chamfer on the teeth for the correct positioning when the new ring gear is installed.
Place the flywheel (2) and the ring gear (4) on a suitable support. Use a hammer and a chisel in order to remove the ring gear (4) from the flywheel (2).
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Bolt (1/2 inch - 20 NF by 4 inch) 2
B 138-7575 Link Bracket 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01148312
Typical example
Remove the two setscrews and install the Tooling (A) as guides. Note: The weight of the flywheel (2) is approximately 54 kg (119 lb). Install the Tooling (B) in order to support the flywheel (2) before the remainder of the setscrews (1) are removed.
Remove the remaining setscrews (1) that secure flywheel (2) to the crankshaft.
Remove the flywheel (2) from the engine.
Illustration 2 g01148313
Check the condition of the ring gear (4). Remove the ring gear (4) if the ring gear is worn or damaged. Note: Identify the orientation of the ring gear (4) on the flywheel (2) and the position of the chamfer on the teeth for the correct positioning when the new ring gear is installed.
Place the flywheel (2) and the ring gear (4) on a suitable support. Use a hammer and a chisel in order to remove the ring gear (4) from the flywheel (2).