AVSPARE.COM
parts catalog

HOSE, BYPASS 7094040C1 - Caterpillar



7094040C1 HOSE, BYPASS Caterpillar parts HOSE
Rating:
21
Alternative (cross code) number:
CA7094040C1
70940-40C1
7094040C1
Caterpillar 7094040C1 HOSE, BYPASS

Buy HOSE, BYPASS 7094040C1 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 1
 
  For full view, you need register

Information:


Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 9 g00924912
Illustration 10 g00924914
Attach two suitable nylon lifting slings around stabilizer frame (15) and to Tooling (C). Install Tooling (D) to the stabilizer frame. Attach Tooling (E) between Tooling (C) and Tooling (D) .Note: Tooling (B) was installed in the removal procedure. If the stabilizer frame is installed for the first time the stabilizer arms must be held in the vertical position. Attach two suitable nylon lifting slings around the stabilizer arms. Connect Tooling (B) between the slings and take up the tension. This will hold the stabilizer arms in a vertical position. Refer to Disassembly and Assembly, "Stabilizer - Remove".
Take up the tension on the lifting slings before adjusting Tooling (E). Carefully lift the stabilizer frame toward the machine. The weight of the stabilizer frame is approximately 680 kg (1500 lb).
Guide the stabilizer frame toward the mounting face on the chassis. At the same time feed the hoses and harnesses into the stabilizer frame.
Illustration 11 g00988404
Install eight bolts (16), the nuts and the washers in order to secure stabilizer frame (15) to the chassis. Remove the lifting equipment.
Illustration 12 g00924916
Connect electrical connector (14) to control valve (11) .
Illustration 13 g00924917
Connect tube (12) to control valve (11) and tighten the hose clamp. Connect four hoses (13) to the control valve.
Illustration 14 g00924918
At the underside of the chassis near the front axle, connect harness (9) to harness (10). Install any cable straps which were removed at the removal.
Illustration 15 g00924919
Feed harness (7) toward the engine enclosure and connect the harness to harness (8). Install any cable straps which were removed at the removal. Close the engine hood.
Illustration 16 g00924920
Feed harness (5) toward the cab and connect the harness to harness (6). Install any cable straps which were removed at the removal.
Illustration 17 g00924922
Install cover (4) .
Illustration 18 g00924923
Remove Tooling (B) and the nylon lifting slings which are supporting stabilizer arms (3) .
Illustration 19 g00924924
Install cover (2). Start the engine and remove Tooling (A). Lower the boom and stop the engine.

Caterpillar parts catalog:

Caterpillar parts catalog
CT13 SCR ON HIGHWAY TRUCK ENGINE JFB00001-UP
CT13 ON HIGHWAY TRUCK ENGINE KBK00001-UP


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.