AVSPARE.COM
parts catalog

HOUSING AS.- 1694700 - Caterpillar



1694700 HOUSING AS.- Caterpillar parts HOUSING
Rating:
66
Alternative (cross code) number:
CA1694700
169-4700
1694700
Caterpillar 1694700 HOUSING AS.-

Buy HOUSING AS.- 1694700 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
The steering circuit temperature monitoring system, if equipped, will alert you when reduced steering performance is detected due to cold temperatures. Failure to respond to this warning could result in injury or death. Ensure that the hydraulic oil type installed in the machine is matched to the hydraulic oil type setting on the display.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
The standard Cat HYDO Advanced oil provides a 100% increase in the standard hydraulic oil change interval for Motor Grader hydraulic systems (4000 hours or 2 years versus 2000 hours or 1 year) over second and third choice oils - when following the maintenance interval schedule for oil filter changes and for oil sampling that is stated in the Operation and Maintenance Manual for your particular machine. 6000 hour or 3 year oil drain intervals are possible when using S O S Services oil analysis. Contact your Cat dealer for details.Note: Non-Hydo Advanced hydraulic oils have a hydraulic oil change interval of 2000 hours or 1 year. By performing S O S oil analysis, the hydraulic oil change interval may be extended to 4000 Service Hours or 2 Years.Note: S O S oil analysis must be performed at every 500 hours or 3 months to extend the hydraulic oil change interval. The results from the S O S oil analysis will determine if the hydraulic oil change interval may be extended. If S O S oil analysis is not available, the hydraulic oil change interval must remain at the minimum change interval determined by the type of hydraulic oil used. Refer to the Operation and Maintenance Manual, "S O S Information" for more information.Operate the machine until the oil is warm.Park the machine on a level surface with the front wheel straight ahead. Lower all attachments to the ground. Apply a slight downward pressure to the attachments. Center the articulation of the machine and install the frame lock pin. The frame lock pin must move freely in the frame. Move the front wheels to vertical and install the wheel lean locking bolt. Engage the parking brake. Stop the engine.The hydraulic system oil tank is positioned behind the left rear access door on the machine.
Illustration 1 g03878491
Clean the area around hydraulic oil filler cap of any dirt or debris. This must be done before the hydraulic oil filler cap can be removed.
Slowly remove the hydraulic oil filler cap to relieve the tank pressure.
Illustration 2 g06303796
Use port (1) and an appropriate pump to drain the oil. Drain the oil into


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.