HOUSING 1695534 - Caterpillar

Table 3
Parameter Description New Value
"One Touch Engine Speed Setting" 1000 rpm
"AESC Setting" 1000 rpm
"AESC Delay Time" 5.0 sec
Change “Throttle Dial Hydraulic Torque Percentages” values for both HHP and ECO.
Illustration 5 g03741854
Throttle Dial Hydraulic Torque Percentages for HHP
Illustration 6 g03741856
Throttle Dial Hydraulic Torque Percentages for ECO
Under the “Throttle Dial Hydraulic Torque Percentages” menu, change the values for the parameters listed in Table 4.
Table 4
Parameter Description HHP ECO
New Value (%) New Value (%)
"Throttle Dial Position 1 Hydraulic System Torque Percentages" 25.0 25.0
"Throttle Dial Position 2 Hydraulic System Torque Percentages" 40.0 40.0
"Throttle Dial Position 3 Hydraulic System Torque Percentages" 61.0 61.0
"Throttle Dial Position 4 Hydraulic System Torque Percentages" 69.0 69.0
"Throttle Dial Position 5 Hydraulic System Torque Percentages" 73.0 70.6
"Throttle Dial Position 6 Hydraulic System Torque Percentages" 73.0 71.9
"Throttle Dial Position 7 Hydraulic System Torque Percentages" 73.0 72.0
"Throttle Dial Position 8 Hydraulic System Torque Percentages" 76.0 72.0
"Throttle Dial Position 9 Hydraulic System Torque Percentages" 87.0 72.0
"Throttle Dial Position 10 Hydraulic System Torque Percentages" 100.0 72.0 You can change the ECO mode parameter after “Economy Mode” is changed to ON and update the configuration (press “F5”).Apply Film
Illustration 7 g03741897
(1) 466-3795 Film (Notice)
Apply 466-3795 Film (Notice) (1) on the cab.The purpose of film (1) is to make aware of this retrofit information. This machine has different engine software and machine software from the standard machine.
Illustration 8 g03741861
View of cab - left side (non-ROPS cab)
(1) 466-3795 Film (Notice)
For non-ROPS cabs, film (1) is on inside the door on the lower left corner. Refer to Illustration 8.
Illustration 9 g03741862
View of cab - left side (ROPS cab)
(1) 466-3795 Film (Notice)
For ROPS cabs, film (1) is on inside the door on the lower right corner. Refer to Illustration 9.ECO Mode Setting Function
Once the new software is flashed, you will get the new ECO mode setting function, which has two main features below.
Default ECO mode setting:
Set “ECONOMY MODE” ON as a default setting.
ECO mode reset function:
The operator can turn the economy mode ON or OFF. The reset function will automatically reset the economy mode to the ON position when the key is turned OFF, and then turned back to the ON position.Note: The operator can disable these features through the monitor. To disable or enable these features, the function is located under the service menu and the service password is required.
Illustration 10 g03662488
Log in to the service mode with the service password. Ask your dealer for the password.
Select “CONFIGURATIONS”
Select “WORK MODE CONFIG”
Change “ECONO MODE” to OFF. Now the “ECONO MODE” is disabled. Note: For work tool users, ECO mode will be temporarily disabled once the work tool is selected.