AVSPARE.COM
parts catalog

HOUSING A. 2H9236 - Caterpillar



2H9236 HOUSING A. Caterpillar parts HOUSING
Rating:
56
Alternative (cross code) number:
CA2H9236
2H-9236
2H9236
Caterpillar 2H9236 HOUSING A.

Buy HOUSING A. 2H9236 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is recorded when the software location code for the ECM does not match the hardware location codes.The probable cause of this diagnostic code is software. The wrong software has been flashed into the ECM.Note: Do not change the hard wired location code if you have flashed the incorrect software into the control.Test Step 1. VERIFY HARDWARE AND SOFTWARE PART NUMBERS
Verify whether the part number of the software for the ECM is correct.Expected Result:Consult the Business Unit that is producing the product for the correct configuration for the machine.Results:
OK - All part numbers are correct for the ECM. Proceed to test step 2.
NOT OK - All part numbers are NOT correct. The installed ECM has the wrong part number or incorrect configuration software is installed.Repair: Replace the ECM with a module that has the correct part number or flash the correct configuration software. See Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program".STOPTest Step 2. VERIFY WHETHER THE LOCATION CODE MATCHES THE ET STATUS SCREEN.
Check the ET status screen in order to verify the location code .Expected Result:The location codes in the ET are correct.Results:
OK - The location codes in the ET are correct. Proceed to test step 3.
NOT OK - The location codes are NOT correct. Repair: Repeat this test step in order to verify that the software and hardware part numbers are correct. Proceed to test step 3 if the part numbers are correct.Test Step 3. INSPECT HARNESS CONNECTIONS
Turn the key start switch and the disconnect switch to the OFF position.
Inspect the harness connections that are related to the location codes. Make sure that the connectors are clean. Make sure that the connectors are tight.
Check for the proper mating of the connector.
Check all wires at the connector.
Check each wire for nicks. Check each wire for signs of abrasion in the insulation.
Check for moisture at the connector.
Check for dirty contacts or corroded contacts.
Check each pin and check each socket.Expected Result:The machine harness connectors are tight and the machine harness connectors are free of corrosion.Results:
OK - The machine harness connectors are tight and the machine harness connectors are free from corrosion.Repair: If the cause of the problem can not be found, The ECM may have failed. Prior to replacing an ECM, always contact your dealership's Technical Communicator for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the cause of the diagnostic code is not found, replace the ECM. Refer to Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - One or more of the machine harness connectors are in need of repair.Repair: Repair the machine harness or replace the machine harness.STOP


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.