AVSPARE.COM
parts catalog

HYDRAULIC AR 3535027 - Caterpillar



3535027 HYDRAULIC AR Caterpillar parts 966K HYDRAULIC
Rating:
85
Alternative (cross code) number:
CA3535027
353-5027
3535027
Caterpillar 3535027 HYDRAULIC AR

Buy HYDRAULIC AR 3535027 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Compatible equipment models: 3535027:

WHEEL LOADER  966K   Caterpillar
  For full view, you need register

Information:

START BY:a. install body retaining pins 1. Remove pressure tap (3) from the lockup clutch valve.2. Fasten a hoist and a 3/8"-16 NC forged eyebolt (2) to guard (1). Remove the bolts that hold the guard to the truck frame, and remove the guard. The weight of the guard is 29 kg (65 lb.). 3. Remove bolts (5) and guard (4). 4. Fasten a hoist to tube (7). Remove the bolts that hold spider (8) to the torque converter and yoke (6), and remove the spider.5. Lower the drive shaft, and remove the hoist. 6. Fasten a hoist to tube (7) as shown. Remove the bolts that hold the spider (9) to the transfer gears and tube (7), and remove the spider. 7. Use the hoist, and move the drive shaft to the rear of the vehicle. Use tool (A) to remove packing cap (10) from yoke (6). Remove the yoke, washers, seal and packing cap from the tube. 8. Lower the hoist, and move it to the center of tube (7). Use the hoist, and lift the tube over the transmission. The weight of the tube is 39 kg (85 lb.).Install Drive Shaft
1. Fasten a hoist to tube (1), and put the tube in position in the machine. 2. Put packing cap (2), washer (5), seal (3), washer (6) and yoke (4) in position on the tube. Install the packing cap on the yoke. 3. Put spider (7) in position between the transfer gears and tube (1), and install the bolts. Tighten the bolts to a torque of 135 15 N m (100 11 lb.ft.). Remove the hoist. 4. Fasten a hoist to the drive shaft as shown. Put spider (8) in position between the torque converter and yoke (4), and install the bolts. Tighten the bolts to a torque of 135 15 N m (100 11 lb.ft.). 5. Put guard (9) and two clips (10) in position, and install the bolts that hold them. 6. Fasten a hoist and a 3/8"-16 NC forged eyebolt to guard (11). Put the guard in position on the truck frame, and install the bolts that hold it.END BY:a. remove body retaining pins

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
966K Series XE Wheel Loader NGX00001-UP (MACHINE) POWERED BY C9.3 Engine


Parts hydraulic Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.