AVSPARE.COM
parts catalog

HYDRAULIC AR-2 VALVE 3967862 - Caterpillar



3967862 HYDRAULIC AR-2 VALVE Caterpillar parts 903C HYDRAULIC
Rating:
72
Alternative (cross code) number:
CA3967862
396-7862
3967862
Caterpillar 3967862 HYDRAULIC AR-2 VALVE

Buy HYDRAULIC AR-2 VALVE 3967862 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER,

Compatible equipment models: 3967862:

COMPACT WHEEL LOADER  903C   Caterpillar
  For full view, you need register

Information:

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below. Problem
Data related to problems and failures of 50MT stator motor cannot be acquired accurately and completely from dealers at non-NACD locations. Moreover, data collection becomes more cost effective due to shipping cost, distance, and language barriers.Solution
Use the following instructions and examples to attach photos to SIMS entries that will help to identify starter motor problems:Needed Information
Illustration 1 g02710356
Illustration shows the part number plate and solenoid date code label located on 50MT stator motor
Provide picture of part number plate. Part Number is the "Part Causing Failure" entered in SIMS. Also provide clear picture of solenoid date code label so that the solenoid date code is clearly visible. Refer to Illustration 1.Note: Part Numbers beginning with 10R or 0R are not CAT OEM parts and should be sent back through REMAN process for core credit according to REMAN Policy SELD0040.Electrical Measurements
Preparation
Remove the following straps prior to take any measurements:
Illustration 2 g02718596
Remove motor-to-solenoid strap (1) as shown in Illustration 2.
Illustration 3 g02718619
Remove commutator end cap ground stud (2) as shown in Illustration 3.Resistance Measurements
Note: Photos are not necessary for resistance measurements.
Illustration 4 g02717047
Illustration 5 g02717056
Check pull-in and hold-in resistance measurements of the solenoid.
Measure hold-in resistance between the terminals (3) and record on log sheet as shown in Illustration 4.
Measure pull-in resistance between the terminals (4) and record on log sheet as shown in Illustration 5.Note: An example of the log sheet is shown in Illustration 8.
Illustration 6 g02711218
(5) Battery (B+) terminal (6) Motor (M) terminal
Illustration 7 g02711234
(7) Solenoid contact disc
Temporarily remove four bolts on solenoid housing to expose the ends of internal Battery (B+) terminal (5), Motor (M) terminal (6), and solenoid contact disc (7). Provide pictures of the Battery (B+) terminal (5) and Motor (M) terminal (6) as shown in Illustration 6.
Loosen three internal screws from terminals for separation of solenoid assembly. Provide pictures of solenoid contact disc (7) as shown in Illustration 7.Log Sheet
Illustration 8 g02717194

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts hydraulic Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.