HYDRAULIC AR 4647239 - Caterpillar

Installation Procedure
Illustration 1 g01238377
Install wiper motor assembly (19). Connect harness assembly (18).
Illustration 2 g01238374
Install nuts (17). Install bolt (16).
Illustration 3 g01238469
Install caps (15).
Use the following procedure to place the wiper motor in the parked position:
Turn the engine start switch to the ON position.
Turn the wiper switch to the OFF position. Wait until the wiper motor stops moving. This is the parked position.
Turn the engine start switch to the OFF position.
Illustration 4 g01238373
Install arm assemblies (12) in the park position. Install bolts (13). Tighten bolts (13) to a torque of 20 3 N m (15 2 lb ft). Connect hose (14).
Turn the engine start switch to the ON position.
Turn the wiper switch to the ON position.
Check the path of wiper arm assemblies (3).
Turn the wiper switch to the OFF position. Wait until the wiper motor stops moving.
Turn the engine start switch to the OFF position.
Makeany necessary adjustments.
Connect hose (14) to the fitting. Note: Do not use petroleum lubricants on the hose ends. Do not stretch the hose between connection points.
Illustration 5 g01238372
Install rear duct (11). Install bolts (10).
Illustration 6 g01238370
Install filter assembly (9).
Illustration 7 g01238366
Install cover assembly (8). Tighten screws (7).
Illustration 8 g01238364
Install headrest (6).
Illustration 9 g01238362
Install armrest assembly (4). Install knobs (5).
Repeat Step 11 for the opposite side.
Illustration 10 g01238355
Engage lever (3) in order to move seat assembly (1) rearward. Install bolt (3).