AVSPARE.COM
parts catalog

INDICATOR 1C4189 - Caterpillar



1C4189 INDICATOR Caterpillar parts INDICATOR
Rating:
21
Alternative (cross code) number:
CA1C4189
1C-4189
1C4189
Caterpillar 1C4189 INDICATOR
Weight: 3 pounds 1 kg.

Buy INDICATOR 1C4189 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

12. Remove ring gear (14) from the axle shaft housing. Using a torch, cut the ring gear in two places 180° apart. Cut the ring gear at the position of the locating dowels in the axle shaft housing. An alternate method is to make three welds equally spaced around the circumference of the ring gear to cause it to shrink. Remove the four locating dowels for ring gear (14). 13. Remove Duo-Cone seal (15) and outer bearing cup (16) from the opposite end of the axle shaft housing. 14. Remove Duo-Cone seal (18) and outer bearing cone (17) from the axle shaft. The following steps are for the assembly of the axle shaft assemblies. 15. Fasten the rim flange of the axle shaft to Tool (G) with suitable size bolts as shown. Heat outer bearing cone (17) to a maximum temperature of 135°C (275°F), and install the bearing cone on the axle shaft as shown. Be sure the bearing cone is seated against the shoulder on the end of the axle shaft. Allow the bearing cone and shaft to cool.
See "Assembly And Installation Of Conventional Duo-Cone Seals" in this module.
The rubber seals and all surfaces that make contact with the seals must be clean and dry. After installation of the seals, put clean SAE 30 oil on the contact surfaces of the metal seals.16. Use Tool (F) to install the Duo-Cone seal in the end of the axle shaft. 17. Lower the temperature of outer bearing cup (16), and install it in the end of the axle shaft housing as shown. Be sure the bearing cup is seated all the way down the axle shaft housing.
See "Assembly And Installation Of Conventional Duo-Cone Seals" in this module.
The rubber seals and all surfaces that make contact with the seals must be clean and dry. After installation of the seals, put clean SAE 30 oil on the contact surfaces of the metal seals.18. Use Tool (F) to install the Duo-Cone seal in the end of the axle shaft housing. 19. Lower the temperature of inner bearing cup (13), and install it in the opposite end of axle shaft housing as shown. Be sure the bearing cup is seated all the way down against the shoulder in the axle shaft housing. Four dowels (19) are used to locate and hold ring gear (14) in position in the axle shaft housing. The four dowels are not equally spaced.20. Locate the position of the ring gear in relation to the axle shaft housing by aligning the half holes for the four dowels. Put alignment marks on the ring gear and axle shaft housing to ensure correct installation.21. Lower the temperature of ring gear (14) to a temperature of -38°C (-36°F). Install four dowels (19) in the half holes on the outside diameter of the ring gear. Use an O-ring seal or rubber band to hold the four dowels in position.22. Using a press, install ring gear (14) in the axle shaft housing. Install the


Parts indicator Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.