parts catalog

INNER BEARING (CONE) 0004131 - Caterpillar

0004131 INNER BEARING (CONE) Caterpillar parts WE-601B INNER
Alternative (cross code) number:
Caterpillar 0004131 INNER BEARING (CONE)

Buy INNER BEARING (CONE) 0004131 Caterpillar genuine, new aftermarket tractor parts with delivery

Compatible equipment models: 0004131:

WINDROW ELEVATOR  WE-601B   Caterpillar
Number on catalog scheme: 30
  For full view, you need register


Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 425-0952 Chock 2
B 504-9792 Lift Gp 2
C 5P-7311 Chain Puller 1 Start By:
Remove the drive shaft.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01389301
Use Tooling (A) to chock the front wheels.
Illustration 2 g06275129
Typical example
Illustration 3 g06275133
Typical example
Position Tooling (B) as shown in Illustration 2. Raise the rear of the machine until the rear wheels are off the ground. Refer to Tool Operating Manual , NEHS1303 for more information on Tooling (B).
Drain the oil from the tandem housing into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Tandem Drive Oil - Change".
Illustration 4 g01389308
Remove walkways (1).
Illustration 5 g01389312
Remove bolts (2) to remove cover (3) and gasket (4). Discard gasket (4). Remove bolts (5) to remove cover (6) and gasket (7). Discard gasket (7).
Illustration 6 g01389655
Install Tooling (C). Remove cotter pins (8). Disconnect master link (9).
Illustration 7 g01389657
Use a suitable lifting device to remove drive chain (10). The weight of drive chain (10) is approximately 40 kg (90 lb).
Repeat Step 7 for the remaining drive chains.

Caterpillar parts catalog:

Caterpillar parts catalog

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.