AVSPARE.COM
parts catalog

INSTALLATION AR-ENGINE 2278419 - Caterpillar



2278419 INSTALLATION AR-ENGINE Caterpillar parts CP-433E, CS-433E INSTALLATION
Rating:
11
Alternative (cross code) number:
CA2278419
227-8419
2278419
Caterpillar 2278419 INSTALLATION AR-ENGINE

Buy INSTALLATION AR-ENGINE 2278419 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 2278419:

VIBRATORY COMPACTOR  CP-433E   CS-433E   Caterpillar
  For full view, you need register

Information:


Illustration 1 g06042461
(1) Filler cap
(2) Engine oil level gauge
Remove filler cap (1) to ensure that the crankcase pressure is equal to the atmospheric pressure.Excess pressure or a slight vacuum will affect engine oil level that is measured.
Ensure that engine oil level gauge (2) is seated.
Illustration 2 g00735162
(3) "ENGINE STOPPED WITH OIL COLD" side
(4) "ENGINE AT LOW IDLE WITH WARM OIL" side
(5) "ADD" mark
(6) "FULL" mark
If the engine is stopped, remove the engine oil level gauge. Observe the engine oil level on "ENGINE STOPPED WITH OIL COLD" side (3).
If the engine is operating, reduce the engine speed to low idle. Remove the engine oil level gauge and observe the engine oil level on "ENGINE AT LOW IDLE WITH WARM OIL" side (4).The engine oil level should be between "ADD" mark (5) and "FULL" mark (6).
Engine damage can occur if the crankcase is filled above the "FULL" mark on the oil level gauge (dipstick).An overfull crankcase can cause the crankshaft to dip into the oil. This will reduce the power that is developed and also force air bubbles into the oil. These bubbles (foam) can cause the following problems: reduction of the oil's ability to lubricate, reduction of oil pressure, inadequate cooling, oil blowing out of the crankcase breathers and excessive oil consumption.Excessive oil consumption will cause deposits to form on the pistons and in the combustion chamber. Deposits in the combustion chamber lead to the following problems: guttering of the valves, packing of carbon under the piston rings and wear of the cylinder liner.If the oil level is above the "FULL" mark on the oil level gauge, drain some of the oil immediately.
If necessary, add engine oil. For the correct engine oil to use, refer to this Operation and Maintenance Manual, "Refill Capacities and Recommendations" topic (Maintenance Section). Do not fill the crankcase above the "FULL" mark on the engine oil level gauge. Clean the filler cap (1). Install the filler cap.
Record the amount of engine oil that is added. For the next engine oil sample and analysis, include the total amount of engine oil that has been added since the previous oil change. This procedure will help to provide the most accurate analysis.

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
CS/CP-433E Vibratory Compactor BTT00001-UP (MACHINE) POWERED BY 3054C Engine
CS/CP-433E Vibratory Compactor ASN00001-UP (MACHINE) POWERED BY 3054C Engine


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.