AVSPARE.COM
parts catalog

KIT-SEAL 1247006 - Caterpillar



1247006 KIT-SEAL Caterpillar parts M312 KIT
Rating:
23
Alternative (cross code) number:
CA1247006
124-7006
1247006
Caterpillar 1247006 KIT-SEAL
Weight: 0.49 pounds 0 kg.

Buy KIT-SEAL 1247006 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEELED EXCAVATOR,

Compatible equipment models: 1247006:

WHEELED EXCAVATOR  M312   Caterpillar
Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g02112654
Schematic of the Screed Left Extender Retract (In) SolenoidThis diagnostic code is associated with the Screed Left Extender Retract (In) Solenoid. The FMI 03 means that the Implement ECM has detected that the voltage of the solenoid circuit is above normal or that the ECM has detected voltage in the circuit when no voltage should be present.Note: The Implement (Screed) ECM is located under the screed platform.Conditions which cause this diagnostic code to activate include the following:
The energize circuit of the solenoid is shorted to another voltage source.
The ECM has failed. This situation is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. System Response:When this diagnostic code is active, the following occurs:
Left extender will move to the fully retracted position.
Operator station fault lamp is active.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness at the solenoid for the Left Extender Retract hydraulic valve. Disconnect the machine harness connectors J1 and J2 from the ECM.
At the machine harness ECM connectors, measure the resistance from contact J2-6 (wire K845-OR) to all of the other contacts that are used in the J1 and J2 connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
YES - Each resistance measurement is greater than 5000 ohms. The resistance measurement does not indicate a short in the machine harness. Proceed to Test Step 2.
NO - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. Repair: The short is between wire K845-OR and the circuit that has a low resistance measurement.For information on testing for short circuits and finding short circuits, refer to Troubleshooting, "Wiring Harness (Short Circuit) - Test". Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the machine harness connector J2 for the ECM, use a 151-6320 Removal Tool to remove the solenoid energize wire K845-OR and socket at contact J2-6 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 2556 FMI 03 diagnostic code.Expected Result:The CID 2556 FMI 03 diagnostic code is

Caterpillar parts catalog:

Caterpillar parts catalog
M312 Excavator 6TL00001-00409 (MACHINE) POWERED BY 3054 Engine


Parts kit Caterpillar catalog:

1028801 KIT-RECEPTACLE
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 267, 267B,...
3532207 KIT-ROD BEARING
206, 212, 3054, 3054B, 3054C, 307, 312, 312B L, 312C, 315, 315B L, 317, 414E, 416B, 416C, 416D, 416E, 420D, 420E, 422E, 424D, 426B, 426C, 428, 428B, 428C, 428E, 430D, 430E, 432E, 434E, 436C, 438C, 442...
3537428 KIT-BEARING
206, 212, 3054, 3054B, 307, 312, 312B L, 312C, 315, 315B L, 317, 416B, 416C, 416D, 420D, 426B, 426C, 428, 428B, 428C, 430D, 436C, 438C, 554, 908, 914G, AP-800C, BG-225C, CB-424, CB-434B, CB-434C, CB-5...
3537429 KIT-BEARING
206, 212, 3054, 3054B, 307, 312, 312B L, 312C, 315, 315B L, 317, 416B, 416C, 416D, 420D, 426B, 426C, 428, 428B, 428C, 430D, 436C, 438C, 554, 908, 914G, AP-800C, BG-225C, CB-424, CB-434B, CB-434C, CB-5...
3537430 KIT-BEARING
206, 212, 3054, 3054B, 307, 312, 312B L, 312C, 315, 315B L, 317, 416B, 416C, 416D, 420D, 426B, 426C, 428, 428B, 428C, 430D, 436C, 438C, 554, 908, 914G, AP-800C, BG-225C, CB-424, CB-434B, CB-434C, CB-5...
1217034 KIT-FUEL PUMP
216, 228, 236, 247, 248, 267, 287, 3034, 3054, 3054B, 307, 312C, 315B L, 416B, 416C, 416D, 420D, 426C, 428B, 428C, 428D, 432D, 436C, 438C, 438D, 442D, 906, 914G, CB-434C, CB-534B, CB-534C, CB-535B, CP...
1028804 KIT-RECEPTACLE
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 267, 267B,...
2340636 KIT-WATER PUMP
3054, 3054B, 3056, 3056E, 312B L, 312C, 315B L, 416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 554, 908, 924G, 924GZ, 930G, AP-655C, AP-800C, BB-760, BG-225B, BG-225C, C...
9T2837 KIT-SEAL
216, 216B, 216B3, 226B, 226B3, 227, 232B, 236, 236B, 236B3, 242B, 242B3, 245, 247, 247B, 247B3, 252B, 252B3, 257B, 257B3, 259B3, 267, 267B, 287, 307B, 312B L, 315B L, 317B LN, 318B, 320B, 322B L, 322B...
2012485 KIT-PLUNGER
215D, 227, 933C, 939C, D3C III, D4C III, D5C III, M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318C MH, M318D, M318D MH, M320, M322C, M322D, M322D MH, M325D L ...
1778782 KIT-WATER PUMP
3054, 3054B, 3056, 3056E, 312C, 315B L, 550B, 554, 560B, 564, 574B, BG-225C, CS-563E, M312, M315
1773310 KIT-GASKET
3054, 914G, IT14G, M312, M315
2860114 KIT-SEAL
M312, M313C, M313D
1265679 KIT-SEAL
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2
0966788 KIT-RING
307, 307B, E70, E70B
7I2320 KIT-GEAR
307, 307B, E70B
7I2315 KIT-GEAR
307, 307B, E70B
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.