LEVELING GP-FRAME 4645068 - Caterpillar

Illustration 1 g03015296
Rear view
Table 1
Specification for 213-8468 Flywheel Housing Gp
Item Qty Part Specification Description
Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the cylinder block. The components must be free from oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material.
To seal the joint between the flywheel housing and the cylinder block, apply Loctite high flex GM to the mating surface of the flywheel housing.
Tighten the bolts that hold the flywheel housing to the engine block evenly. Refer to Illustration 1 and Table 1 for the locations and for identification of the bolts.
1 4 9X-8875 Bolt Length of one 1/2 inch bolt is 88.9 mm (3.50 inch).
Torque to 135 20 N m (100 15 lb ft).
2 2 1A-7669 Bolt Length of one 1/2 inch bolt is 177.8 mm (7.00 inch).
Torque to 135 20 N m (100 15 lb ft).
3 6 9X-8873 Bolt Length of one 1/2 inch bolt is 57.15 mm (2.250 inch).
Torque to 135 20 N m (100 15 lb ft).
4 2 9S-1374 Bolt Length of one 1/2 inch bolt is 203.2 mm (8.00 inch).
Torque to 135 20 N m (100 15 lb ft).
5 16 1D-4590 Bolt Length of one 5/8 inch bolt is 120.65 mm (4.750 inch).
Torque to 270 40 N m (199 30 lb ft).
6 4 8S-9089 Bolt Length of one 1/2 inch bolt is 114.3 mm (4.50 inch).
Torque to 135 20 N m (100 15 lb ft).