AVSPARE.COM
parts catalog

LINES GP- 2278817 - Caterpillar



2278817 LINES GP- Caterpillar parts LINES
Rating:
46
Alternative (cross code) number:
CA2278817
227-8817
2278817
Caterpillar 2278817 LINES GP-

Buy LINES GP- 2278817 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Machine Shipping
For basic standard machine shipping specifications see the topic Specifications and Model Views in the General Section of this manual.
Remove ice, snow or other slippery material from shipping machine and loading dock, before loading the machine.
Always block the trailer or rail car wheels before loading the machine.Load the machine with rear end forward to prevent the cab door from coming open during transportation. Move the transmission control lever (1) to NEUTRAL.Lower three-point hitch (2). Engage the parking brake. Place the governor control lever in the LOW IDLE position. Turn the engine start switch key to OFF-LOCKED and removed the key.Install tiedowns as shown in the illustration in the topic Machine Lifting and Tiedown in this section. Block the drive belts front and rear.Do not fasten tie-downs to belt tensioner cylinder.Cover the engine exhaust opening to prevent turbocharger windmilling in transit.Comply with regulations governing weight, width and length of load.Contact your Caterpillar dealer for shipping instructions for your machine.
In freezing weather, protect the cooling system with antifreeze, to the lowest outside expected temperature on the travel route. Or, drain the cooling system completely.
Machine Roading
Check all fluid levels and idler pressures before traveling.Check the travel route for overpass clearances. Make sure there is adequate clearance.Check and obey all local and all traffic regulations. Make sure the Three-Point Hitch Mode Switch is in the OPERATING MODE position. If roading with a mounted implement, use the adjustable depth stop to lock the control lever in the FULLY RAISED position.Machine Lifting and Tiedown
Improper lifting or tiedown will allow the load to shift and can cause injury or damage.
1. Weight and instructions given here apply to machines as manufactured by Caterpillar Inc.Approximate weight = 13 990 kg (30,800 lbs).2. Use proper rated cables and slings for lifting. Position crane for level lift.3. Spreader bar width must be sufficient to prevent contact with the machine.4. Remove the frame mounted front step and the left handhold for lifting.5. On machines with three-point hitch, the hitch must be raised to the "MAXIMUM UP" position for lifting.6. On machines not equipped with three-point hitch, the cables must be attached to the drawbar support at or on the outside of the outer pin holes.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.