AVSPARE.COM
parts catalog

LINES GP-A/C 3157274 - Caterpillar



3157274 LINES GP-A/C Caterpillar parts LINES
Rating:
81
Alternative (cross code) number:
CA3157274
315-7274
3157274
Caterpillar 3157274 LINES GP-A/C

Buy LINES GP-A/C 3157274 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g06002462
Connections of the 5 VDC Sensor Power Supply Circuits.
This diagnostic code is associated with the 5 VDC Power Supply for the sensors. An FMI 04 means that the Transmission ECM has determined that the voltage of the 5 VDC sensor power supply is below normal.The possible causes of the diagnostic code are:
A sensor has failed.
The 5 VDC sensor power supply is shorted to ground.
The Transmission ECM might have failed but that is unlikely.Test Step 1. CHECK ALL OF THE 5 VOLT SENSORS
Turn the disconnect switch and the key start switch to the ON position.
Ensure that the diagnostic code is active.
One at a time, disconnect each sensor on the machine that is connected to the 5 VDC power supply contact J1-11 (wire T997-OR(Orange)). Observe the status of the diagnostic code each time you disconnect a sensor.If the results are OK, fully reconnect one sensor before proceeding to disconnect the next.Expected Result:The CID 0262 FMI 04 diagnostic code remains active.Results:
OK - The CID 0262 FMI 04 diagnostic code remains active. The sensor is correct. Continue testing the sensors and proceed to Test Step 2 only after all the required sensors have been tested, and all have proven correct.
NOT OK - The diagnostic code is no longer active. The sensor has failed.Repair: Replace the failed sensor.STOPTest Step 2. CHECK THE WIRING HARNESS FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the J1 and J2 machine harness connectors from the transmission ECM.
Disconnect all the 5 VDC sensors connected to contact J1-11 (wire T997-OR(Orange)) from the machine harness.
At the J1 harness connector for the transmission ECM, measure the resistance from contact J1-11 (wire T997-OR(Orange)) to all possible sources of ground. Measure also the resistance from contact J1-11 (wire T997-OR(Orange)) to all the other contacts on both the J1 and J2 connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - One or more resistance measurements are not correct. There is a short in the machine harness.Repair: The short is between signal contact J1-11 (wire T997-OR(Orange)) and the circuit with the lowest resistance measurement. Repair, or replace, the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect the contacts of the harness connectors. Clean all the contacts of the harness connector.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0262 FMI 04 diagnostic code.Expected Result:The CID 0262 FMI 04 diagnostic code is no longer active.Results:
YES - The CID 0262 FMI 04 diagnostic code is no longer active. The diagnostic code has been corrected.Repair: The diagnostic code was probably caused by a poor electrical connection that was resolved when a harness connector was disconnected and reconnected. Resume normal machine operations.STOP
NO - The CID 0262 FMI 04 diagnostic code is still active. The diagnostic code has not been


Parts lines Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.