AVSPARE.COM
parts catalog

LINES GP-EXHAUST 3534454 - Caterpillar



3534454 LINES GP-EXHAUST Caterpillar parts BG1000E, BG1055E LINES
Rating:
86
Alternative (cross code) number:
CA3534454
353-4454
3534454
Caterpillar 3534454 LINES GP-EXHAUST

Buy LINES GP-EXHAUST 3534454 Caterpillar genuine, new aftermarket tractor parts with delivery
ASPHALT PAVER,

Compatible equipment models: 3534454:

ASPHALT PAVER  BG1000E   BG1055E   Caterpillar
Number on catalog scheme: 3
 
  For full view, you need register

Information:

Clean the Cooling System Relief Valve
Clean or replace the relief valve if the system overheats or loss of coolant is observed. There are two valves to be cleaned. One on the tractor engine radiator and one on the scraper engine radiator.1. Unlatch and open the hood to gain access to the valve.2. Remove the bolts from the valve and remove the valve assembly. 3. Inspect valve (1), valve seal (2) and gasket (3). Replace the valve assembly, gasket and seals if they are damaged.4. Inspect the relief valve cover and mounting bolts.5. Install the valve assembly and mounting bolts.Filling the Radiator
All water is corrosive at engine operating temperatures. Use a Caterpillar coolant conditioner element to treat either plain water or ethylene glycol solution.Do not use Caterpillar coolant conditioner elements with Dowtherm 209 Full-Fill coolant. Follow recommendations provided with Dowtherm 209 Full-Fill coolant.If the machine is to be shipped to, or stored in, an area with temperatures below 0°C (32°F), the cooling system must be protected to the lowest expected ambient temperature.Clean the cooling system if it is contaminated, if engine overheats or if foaming is observed in the radiator.
Use clean water that is low in scale forming minerals - not softened water. Measure the specific gravity of the antifreeze solution frequently in cold weather to ensure adequate protection.1. 621E - Change the coolant conditioner element. See the topic "Cooling System - Changing Coolant Conditioner Element" under "Every 250 Service Hours or Monthly."2. 627E - Do not completely fill the cooling systems. Allow for addition of Caterpillar cooling system conditioner.Mix the antifreeze solution to provide protection to the lowest expected outside temperature. See "Refill Capacities." To help avoid locks, add coolant slowly, at 20 liters (5 U.S. gallons) per minute or less. Fill the radiator to the indicator plate in the fill pipe.627E - Add 1.9 liters (2 quarts) of Caterpillar cooling system conditioner or equivalent.3. Start and run the engine with the radiator cap removed. Allow the coolant to warm and the level to stabilize. Add coolant if necessary. Stop the engine. Check for leaks. 4. Inspect the radiator cap gasket. Replace the gasket if it is damaged. Install the cap.627E
Repeat the procedures in the same sequence for the scraper engine cooling system.Engine Valve Lash
Adjust
To prevent possible injury, do not use the starter motor to turn the flywheel.Hot engine components can cause burns. Allow additional time for the engine to cool before measuring valve clearance.
Measure the valve lash with the engine stopped. To obtain an accurate measurement, allow at least 20 minutes for the valves to cool to engine cylinder head and block temperature.
Adjust the valve clearance to within 0.08 mm (.003 in) of the nominal clearance given.621E Tractor
Refer to the Service Manual or your Caterpillar dealer for the complete valve adjustment procedure.After setting valve clearances and before installing the valve cover, check valve rotators. See next topic.627E Tractor and Scraper Engine
Refer to the Service Manual or your Caterpillar dealer for the complete valve adjustment procedure.Engine Valve

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
AP1055E BG1055E Asphalt Paver FRR00001-UP (MACHINE) POWERED BY C7.1 Engine
AP1000E BG1000E Asphalt Paver RTT00001-UP (MACHINE) POWERED BY C7.1 Engine


Parts lines Caterpillar catalog:

3565613 LINES GP-TURBOCHARGER OIL
120M 2, 2570C, 2670C, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 950K, 962K, BG1000E, BG1055E, C7.1
3496133 LINES GP-AIR
2570C, 2670C, 2864C, 563C, 573C, 586C, 627H, BG1000E, BG1055E, C13, C7.1, C9.3, D6T LGP, D6T XL, D7E, D7E LGP
2780358 LINES GP-SPRAY DOWN
AP-600D, AP-655D, AP1000E, AP1055E, AP555E, BG1000E, BG1055E, BG500E, BG600D, BG655D
3367901 LINES GP-CYLINDER
AP1000E, AP1055E, BG1000E, BG1055E
3367906 LINES GP-GRADE & SLOPE
AP1000E, AP1055E, BG1000E, BG1055E
3454135 LINES GP-FUEL INJECTION
120M 2, 2384C, 2484C, 2570C, 2670C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 525D, 535D, 545D, 555D, 559C, 563C, 573C, 579C, 924K, 930K, 938K, 95...
7W1619 LINES GP-WATER
G3408, G3408B, G3408C, G3412
5I7061 LINES GP-STICK
330, 330 FM L, 330 L
3225900 LINES GP-FUEL
D3K XL, D4K XL, D5K LGP
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.