4645544 LINES GP-AIR Caterpillar parts LINES
Rating:
Alternative (cross code) number:
CA4645544
464-5544
4645544
CA4645544
464-5544
4645544
Buy LINES GP-AIR 4645544 Caterpillar genuine, new aftermarket tractor parts with delivery
Information:
Illustration 1 g01078877
Schematic of the Solenoid Valve for blade tilt rightThis diagnostic code is associated with the solenoid valve for blade tilt right. The FMI 06 means that the ECM has determined that there is a short to ground in the solenoid circuit.The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 497 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the current that is supplied to the solenoid valve for blade tilt right is set to zero. The Raise and Lower functions should continue to operate normally.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness.Expected Result:CID 497 FMI 06 changes to CID 497 FMI 05 when the solenoid is disconnected.Results:
YES - CID 497 FMI 06 changes to CID 497 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - CID 497 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J1-65 (wire M928-BU) to all contacts that are used in the machine harness connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-65 (wire M928-BU) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 497 FMI 06.Expected Result:The CID 497 FMI 06 is active.Results:
YES - The CID 497 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace
Caterpillar SIS machinery equipment:
Caterpillar SIS
- D6T Track-Type Tractor XL, XW, LGP HNK00001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6 Track-Type Tractor GZ900001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6T Track-Type Tractor, XL VPAT, XW VPAT, LGP VPAT KTW00001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6T Track-Type Tractor XL VPAT, XE; XW VPAT, XE; LGP VPAT, XE D5M00001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6T Track-Type Tractor XL VPAT, XW VPAT, LGP VPAT AG900001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE HFE00001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6 Track-Type Tractor LRG00001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
- D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE B7200001-UP (MACHINE) POWERED BY C9.3 Engine » 464-5544 LINES GP-AIR
Caterpillar parts catalog:
Parts lines Caterpillar catalog:
4645147
LINES GP-F PRM
Caterpillar
Caterpillar
4645141
LINES GP-F PRM
Caterpillar
Caterpillar
4645138
LINES GP-F PRM
Caterpillar
Caterpillar
4645070
LINES GP-PILOT
Caterpillar
Caterpillar
4643971
LINES GP-F PRM
Caterpillar
Caterpillar
4643541
LINES GP-CNTOR
Caterpillar
Caterpillar
4645977
LINES GP-INSTR
Caterpillar
Caterpillar
4645743
LINES GP-WATER
Caterpillar
Caterpillar
4645742
LINES GP-WATER
Caterpillar
Caterpillar
4645642
LINES GP-WATER
Caterpillar
Caterpillar
4645555
LINES GP-AIR
Caterpillar
Caterpillar
4645545
LINES GP-DEF
Caterpillar
Caterpillar