AVSPARE.COM
parts catalog

LINES GP-WATER 4645743 - Caterpillar



4645743 LINES GP-WATER Caterpillar parts LINES
Rating:
26
Alternative (cross code) number:
CA4645743
464-5743
4645743
Caterpillar 4645743 LINES GP-WATER

Buy LINES GP-WATER 4645743 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g01079280
Schematic of the Solenoid Valve for blade lowerThis diagnostic code is associated with the solenoid valve for the blade lower. The FMI 06 means that the ECM has determined that there is a short to ground in the solenoid circuit.The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1197 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active the hydraulic control system will default to the "Service Mode" state.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness.Expected Result:CID 1197 FMI 06 changes to CID 1197 FMI 05 when the solenoid is disconnected.Results:
YES - CID 1197 FMI 06 changes to CID 1197 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - CID 1197 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J1-68 (wire H714-OR) and H803-BU to all contacts that are used in the machine harness connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-68 (wire H714-OR) and H803-BU.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1197 FMI 06.Expected Result:The CID 1197 FMI 06 is active.Results:
YES - The CID 1197 FMI 06 is active.

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
D6T Track-Type Tractor XL VPAT, XE; XW VPAT, XE; LGP VPAT, XE D5M00001-UP (MACHINE) POWERED BY C9.3 Engine
D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE HFE00001-UP (MACHINE) POWERED BY C9.3 Engine
D6 Track-Type Tractor LRG00001-UP (MACHINE) POWERED BY C9.3 Engine
D6T Track-Type Tractor XL, XE; XW, XE; LGP, XE B7200001-UP (MACHINE) POWERED BY C9.3 Engine


Parts lines Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.