parts catalog

LINES GP-BUCKET 5088337 - Caterpillar

5088337 LINES GP-BUCKET Caterpillar parts LINES
Alternative (cross code) number:
Caterpillar 5088337 LINES GP-BUCKET

Buy LINES GP-BUCKET 5088337 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 6
  For full view, you need register


Illustration 1 g02362701
Transmission Solenoids are located on the left side of the transmission.
(1) "Transmission solenoid 1 (forward high)"
(2) "Transmission solenoid 2 (forward low)"
(3) "Transmission solenoid 3 (reverse)"
(4) "Transmission solenoid 4 (2nd speed)"
(5) "Transmission solenoid 5 (3rd speed)"
(6) "Transmission solenoid 6 (1st speed)"
(7) "Transmission solenoid 7 (low range)"
(8) "Transmission solenoid 8 (high range)"
Illustration 2 g02362702
Connections for "Transmission Solenoid 7"
This diagnostic code is associated with the "Transmission Solenoid 7". The FMI 03 means that the "Transmission/Chassis ECM" has determined that the voltage of the solenoid circuit is above normal.Conditions that can cause this diagnostic code are listed below:
The energize circuit of the solenoid is shorted to another voltage source.
The ECM has failed. A failure of the Transmission/Chassis ECM is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the solenoid. Disconnect the machine harness connectors J1 and J2 from the "Transmission/Chassis ECM".
At the machine harness connector J1 of the ECM, measure the resistance between contact J1-48 (wire 902-BR(Brown)) and all of the J1 and J2 contacts that are used on the Transmission/Chassis ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between wire 902-BR(Brown) and the circuit that has a low resistance measurement. Repair: For information on testing for short circuits and finding short circuits, refer to Testing and Adjusting, "Wiring Harness (Short Circuit) - Test". Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the machine harness connector J1 for the ECM, use a 151-6320 Removal Tool to remove the energize wire of the solenoid 902-BR(Brown) and the socket at contact J1-48 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 1407 FMI

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
BD118 & BD121 Side Discharge Buckets BND00001-UP (MACHINE)

Parts lines Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.