AVSPARE.COM
parts catalog

LOCK AS 3967961 - Caterpillar



3967961 LOCK AS Caterpillar parts 349D L, 374D L, 374F L, 385C, 385C FS, 390D, 390D L, 390F L LOCK
Rating:
78
Alternative (cross code) number:
CA3967961
396-7961
3967961
Caterpillar 3967961 LOCK AS
Weight: 3 pounds 1 kg.

Buy LOCK AS 3967961 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, FRONT SHOVEL,

Compatible equipment models: 3967961:

EXCAVATOR  349D L   374D L   374F L   385C FS   390D   390D L   390F L  
FRONT SHOVEL  385C   Caterpillar
Number on catalog scheme: 4
 
  For full view, you need register

Information:


Illustration 1 g01197149
Schematic for the Tilt Tiltback SolenoidThis diagnostic code is recorded when the ECM detects a short to ground in the electrical path from the ECM to the solenoid. The possible causes for this diagnostic code are listed:
The internal windings for the solenoid have low impedance.
The internal windings for the solenoid are shorted.
The signal circuit from the ECM to the solenoid is shorted to ground.System Response:The machine response is listed:
The tilt linkage will not tilt back.
The tilt back detent coil will be disabled.
The implements will be disabled until the fault is corrected and the levers are centered.Note: All solenoid return lines connect to contact J1-50 (wire J813-BK) of the implement ECM.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code indicator is active and that the diagnostic code is active.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position.
Observe the ON/OFF status of the diagnostic code indicator.
Disconnect the solenoid with the diagnostic code from the harness.Expected Result:The diagnostic code indicator remains active.Results:
YES - The diagnostic code indicator remains active and the diagnostic code remains active. The harness has failed or the ECM has failed. Proceed to Test Step 2.
NO - The diagnostic code indicator is inactive.Repair: The solenoid has failed or the connecting harness has failed. Repeat this test in order to verify the failure. Repair the solenoid or replace the solenoid. Repair the connecting harness or replace the connecting harness at the solenoid. Stop.Test Step 2. CHECK FOR A SHORTED HARNESS.
Turn the disconnect switch to the OFF position.
The solenoid valve from the previous test step remains disconnected.
Disconnect the harness from the implement ECM.
At the harness connector for the ECM, measure the resistance between contact for the failed solenoid circuit J1-51 (wire E921-PK) and contact J1-50 (ground wire J813-BK).Expected Result:The resistance is less than 5000 Ohms.Results:
YES - The resistance is less than 5000 Ohms.Repair: The harness has failed. The corresponding solenoid wire is shorted to ground in the harness. Repair the harness or replace the harness. Stop.
NO - Resistance is greater than 5000 Ohms (no continuity).Repair: The harness circuit resistance is correct. It is unlikely that the ECM has failed. Exit this procedure and perform this troubleshooting procedure again. Also recheck if the diagnostic code indicator is active for this diagnostic code. If the cause is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.

Cat SIS web machinery list:

Caterpillar parts catalog
390F L Excavator HNG00001-UP (MACHINE) POWERED BY C18 Engine
MH3295 Material Handler PA900001-UP (MACHINE) POWERED BY C18 Engine
349D2 Mobile Hydraulic Power Unit P2700001-UP (MACHINE) POWERED BY C13 Engine
349D2 L Excavator GAX00001-UP (MACHINE) POWERED BY C13 Engine
374F L Excavator EBF00001-UP (MACHINE) POWERED BY C15 Engine
390F L Excavator FEH00001-UP (MACHINE) POWERED BY C18 Engine
390F OEM PT700001-UP (MACHINE) POWERED BY C18 Engine
349D2 L Excavator WEC00001-UP (MACHINE) POWERED BY C13 Engine
385C FS Excavator MMA00001-UP (MACHINE) POWERED BY C-18 Engine
385C FS Excavator EAM00001-UP (MACHINE) POWERED BY C-18 Engine
385C Material Handler WAW00001-UP (MACHINE) POWERED BY C-18 Engine
390D L Excavator WAG00001-UP (MACHINE) POWERED BY C18 Engine
390D L Excavator WBT00001-UP (MACHINE) POWERED BY C18 Engine
390D L Excavator WAP00001-UP (MACHINE) POWERED BY C18 Engine
374D L Excavator PJA00001-UP (MACHINE) POWERED BY C15 Engine
374D L Excavator PAX00001-UP (MACHINE) POWERED BY C15 Engine
374D L Excavator PAP00001-UP (MACHINE) POWERED BY C-15 Engine
374D L Excavator PAS00001-UP (MACHINE) POWERED BY C15 Engine
390D Excavator BYP00001-UP (MACHINE) POWERED BY C18 Engine
390D Excavator KCZ00001-UP (MACHINE) POWERED BY C18 Engine
385C L Mobile Hydraulic Power Unit M3W00001-UP (MACHINE) POWERED BY C18 Engine
349D & 349D L Excavators MEN00001-UP (MACHINE) POWERED BY C13 Engine
349D L Excavator WTD00001-UP (MACHINE) POWERED BY C13 Engine
349D & 349D L Excavators GKF00001-UP (MACHINE) POWERED BY C13 Engine
349D2 & 349D2 L Excavators YAG00001-UP (MACHINE) POWERED BY C13 Engine
374F L Excavator MFL00001-UP (MACHINE) POWERED BY C15 Engine
374F L Excavator DNM00001-UP (MACHINE) POWERED BY C15 Engine
349D L Excavator FLA00001-UP (MACHINE) POWERED BY C13 Engine
390F L Excavator MGF00001-UP (MACHINE) POWERED BY C18 Engine
349D2 & 349D2 L Excavators RAN00001-UP (MACHINE) POWERED BY C13 Engine
390F L Excavator HSM00001-UP (MACHINE) POWERED BY C18 Engine
390F L Excavator TYE00001-UP (MACHINE) POWERED BY C18 Engine
374F L Excavator AP400001-UP (MACHINE) POWERED BY C15 Engine
374F L Excavator AT200001-UP (MACHINE) POWERED BY C15 Engine
349D2, 349D2 L & 349D2 L-VG Excavators PFD00001-UP (MACHINE) POWERED BY C13 Engine
349D2 L Excavators XAC00001-UP (MACHINE) POWERED BY C13 Engine
390F L Excavator GAY00001-UP (MACHINE) POWERED BY C18 Engine
390F L Excavator HJD00001-UP (MACHINE) POWERED BY C18 Engine
374F L Excavator NFJ00001-UP (MACHINE) POWERED BY C15 Engine
390F Mobile Hydraulic Power Unit B3700001-UP (MACHINE) POWERED BY C18 Engine
374F L Excavator XWL00001-UP (MACHINE) POWERED BY C15 Engine
390F L Excavator YHT00001-UP (MACHINE) POWERED BY C18 Engine


Parts lock Caterpillar catalog:

2A4429 LOCK-RETAINER
1140, 1160, 120, 120B, 120G, 120H, 120K, 120K 2, 12E, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 130G, 135H, 140B, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 143H, 14E, 14G, 14H, 14H NA, 14M, ...
5P0372 LOCK PIN
216, 216B, 216B3, 226B, 226B3, 228, 232B, 235C, 235D, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D...
1566600 LOCK AS
307C, 307D, 311C, 311D LRR, 311F LRR, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315C, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 320C, 320C FM, 320C L, 320D...
8T2888 LOCK GP
120G, 12G, 130G, 140G, 14G, 160G, 16G, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 308C, 308D, 375, 375 L, 385B, 385C, 385C FS, 385C L, 38...
2677064 LOCK AS
303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 308D, 308E CR, 308E SR, 312D, 312D L, 312E, 312E L, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D...
3758597 LOCK AS
312D, 312D L, 313D, 315D L, 318D L, 319D L, 319D LN, 320D, 320D FM, 320D GC, 320D L, 320D LN, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325D, 325D L, 326D L, 329D, 329D L, 329D LN, 330D, 330D L...
3346485 LOCK AS-WINDOW
312D, 312D L, 312E, 312E L, 315D L, 316E L, 318E L, 319D L, 319D LN, 320D, 320D L, 320D LRR, 320D RR, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D L, 324E, 32...
3346488 LOCK AS
312D, 312D L, 312E, 312E L, 315D L, 316E L, 318E L, 319D L, 319D LN, 320D, 320D L, 320D LRR, 320D RR, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D L, 324E, 32...
2644501 LOCK AS
345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 374D L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 3...
3077655 LOCK AS
345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 365C, 365C L, 365C L MH, 374D L, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, W345C MH
4225237 LOCK AS
345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, W345C MH
3967962 LOCK AS
374F L, 390F L
2505180 LOCK AS
345C, 345C MH, W345C MH
0858960 LOCK AS
325 L, 325 LN, 330, 330 FM L, 330 L, E240C, E300B, E450
7I1539 LOCK AS
325, 325 L, 330, 330 FM L, 330 L
2709948 LOCK AS
325C, 345B II, 345B L, 365B, 365B II, 365B L
0941447 LOCK
E180, E240, E300
0946317 LOCK
E110, E120, E180, E240, E300, E450, E650, E70
0941309 LOCK
E110, E120, E140, E180, E240, E300, E450, E650, E70
3967962 LOCK AS
374F L, 390F L
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.