parts catalog

NUT 0004363 - Caterpillar

0004363 NUT Caterpillar parts NUT
Alternative (cross code) number:
Caterpillar 0004363 NUT
Weight: 0.47 pounds 0 kg.

Buy NUT 0004363 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 1 g00789849
This calibration procedure will automatically calibrate the initial and the maximum current for the left and the right pump forward solenoids. This calibration will also calibrate the currents for the left and the right motor solenoids. During the calibration procedure, the machine will move.
The tracks will move during the procedure. Keep all personnel away from the machine during the procedure. Severe injury or death could result if someone was caught in the moving tracks.
Note: In order to place the machine on stands, refer to Testing and Adjusting, "Service Brake Pedal - Test".
Illustration 2 g00789854
Use Caterpillar® Electronic Technician (Cat ET) to calibrate the following solenoids:
Left pump forward solenoid
Right pump forward solenoid
Left motor solenoid
Right motor solenoidCalibration is required in the following situations:
A pump or a motor is replaced or a pump or a motor is serviced.
The machine ECM is replaced or the ECM is removed for service.Use Cat ET to calibrate the solenoids. Select Service from the main menu. Then, select "CALIBRATION" from the drop-down menu. Select the "Forward Pump and Motor Solenoid Calibration" from the selection menu. Follow the instructions that are provided.The ECM must detect the following conditions before starting the calibration procedure:
The joystick must be in the neutral position.
The engine must be running and the engine is set to high idle.
There are No Active Diagnostics.
The parking brake switch must be released.If any of these conditions are not met during the calibration, the procedure is aborted immediately.Note: The hydraulic oil temperature must be between 40 °C (104 °F) to 55 °C (131 °F).The following solenoid parameters can be viewed using Cat ET:
Left Drive Pump Forward Control Solenoid Start Current Command
Right Drive Pump Forward Control Solenoid Start Current Command
Left Drive Motor Solenoid Start Current Command
Right Drive Motor Solenoid Start Current Command
Left Drive Pump Forward Control Solenoid Maximum Current
Right Drive Pump Forward Control Solenoid Maximum Current
Left Motor Solenoid Maximum Current
Right Motor Solenoid Maximum CurrentNote: If Error Code : 0103 - "Calibration Out of Range" occurs during calibration, check the PWM signal to ensure that communication is working correctly. If no problem is found with the PWM signal, use Cat ET to view the current values of the given solenoid. The currents of the left and right drive motors or drive pumps should be similar. All of the pump solenoid start currents should be similar and all the pump solenoids maximum currents should be similar. If one current value is obviously different than their counterpart, then troubleshoot that circuit.

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.