O-RING 62000095 - Caterpillar

Secure power link (B) to the stick.
Illustration 7 g00775671
Supports for transportation (1) Front support (2) Stick (3) Rear support
Locate the supports on the ground. Front support (1) will accept pin (C) of the stick. The rear support should be placed 11090 mm (36 ft 4.6 inch ) from the front support.
Lower the front of the stick to the front support.
Illustration 8 g00775850
Front support (A) Stick (C) Pin (D) Block (E) Bolts
Position pin (C) of the stick in the lower half of blocks (D) .
Install the upper half of blocks (D). Secure the blocks with bolts (E) .
Illustration 9 g00775851
Rear support (A) Stick (F) Bracket (G) Pin (H) Lock pin
Lower the boom. Place bracket (F) in the support. Align the holes of the bracket of the stick and the rear support.
Insert pin (G) through the holes of the rear support and the support for the stick. Secure the pin with lock pin (H) .
Stop the engine. Operate the joysticks in order to release the hydraulic pressure.
Illustration 10 g00775923
(2) Stick (4) Stick cylinder (5) Boom nose (6) Couplings (7) Connector (8) Wood (9) Strap (10) Bolt (11) Pin
Secure the stick cylinder to the boom nose with strap (9) .
Disconnect the quick couplings on both sides of the fore boom.
Disconnect connector (7) .
Remove the hydraulic hoses that are connected to the quick couplings. Plug the hydraulic hoses.
Disconnect the grease lines.
Install a block of wood (8) between the stick and the stick cylinder.
Remove bolt (10) and pin (11) .
Lower the stick cylinder to the stick.
Secure the stick cylinder to the stick.
Disconnect the quick couplings on the top of the fore boom.
Remove the hydraulic hoses. Plug the hydraulic hoses.
Disconnect the grease lines.
Disconnect the electrical wiring.
Illustration 11 g00775963
(2) Stick (12) Fore boom (13) Bolt and washer (14) Pin (15) Spacer
Remove bolt (13) and spacer (14) .
Remove spacer (3) .
Start the engine.
Raise the boom.
Drive the machine backward.
Place the stick and the supports on the trailer. Use the four lifting eyes that are on the stick.
Place the supports for the boom and the fore boom onto the trailer. Secure the supports to the trailer.
Secure the stick to the trailer. Refer to Illustration 3 through Illustration 5 for more information.Shipping the Boom Nose and the Fore Boom
Illustration 12 g00775977
(1) Boom nose (2) Back support (3) Front support (4) Bracket (5) Pin (6) Lock pin
Drive the machine to the trailer.
The boom nose is attached to the supports in two places. The fore boom is attached to the support in one place.
Extend the fore boom.
Lower the boom nose and the fore boom to the supports.
Align the holes of bracket (4) and support (3) .
Install pin (5) .
Secure pin (5) with lock pin (6)
Illustration 13 g00775986
(1) Boom nose (7) Bracket (8) Bolt (9) Block (10) Pin
Align bracket (7) of the boom nose with blocks (9) .
Install blocks (9) over bracket (7) of the boom nose.
Install bolts (8) through the blocks and tighten securely.
Install pin (10) in the fore boom.
Lower the fore boom until pin (10) rests in the blocks of the back support.
Install blocks (9) on pin