AVSPARE.COM
parts catalog

PANEL GP 1694944 - Caterpillar



1694944 PANEL GP Caterpillar parts PANEL
Rating:
46
Alternative (cross code) number:
CA1694944
169-4944
1694944
Caterpillar 1694944 PANEL GP

Buy PANEL GP 1694944 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
The ROP Shop Genuine OEM PTO Switch fits Simplicity 1694943 1694944 1694945 1694961 1694962
$27.49
 

14 Jul 2019

Simplicity: Simplicity
The ROP Shop Genuine OEM PTO Switch fits Simplicity 1694943 1694944 1694945 1694961 1694962
New Genuine OEM PTO SWITCH || Fits Simplicity 1694943 1694944 1694945 1694961 1694962 || No. of Positions - 2, No. of Terminals - 2 || Push/Pull Yellow Knob, Snap Mount || Quality Aftermarket Part with 1 Year Warranty
  For full view, you need register

Information:


Illustration 1 g03882804
Schematic of the Cat Data Link circuit
This diagnostic code is recorded when the ECM for the Monitoring System does not receive expected information from the machine ECM through the Cat Data Link.System Response:This failure may cause readouts that depend on the information from the Cat Data Link to display information incorrectly. Test Step 1. VERIFY THE HARDWARE AND THE SOFTWARE PART NUMBERS.
Verify that the following information is correct:
The part number of the flash software for the ECM for the Monitoring System
The part number of the flash software for the machine ECM
The part number of the ECM for the Monitoring System
The part number of the machine ECM Note: Consult the Business Unit that produces the product for the correct part numbers of the configuration software. Expected Result:All part numbers are correct. Results:
OK - All part numbers are correct. Proceed to test step 2.
NOT OK - All part numbers are NOT correct. Repair: The installed ECM for the Monitoring System or the machine ECM has the wrong part number or the incorrect configuration software is installed. Replace the incorrect ECM for the Monitoring System or the machine ECM with a module that has the correct part number. Flash the correct configuration software. See the Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program " section of this manual.STOPTest Step 2. INSPECT THE HARNESS CONNECTIONS.
Turn the disconnect switch to the OFF position.
Inspect all harness connections that are related to the Cat Data Link. Make sure that the connectors are clean and tight.
Check the connectors for proper mating.
Check the wires at the connector.
Check each wire for nicks or signs of abrasion in the insulation.
Check for moisture at the connector.
Check the connectors for dirty contacts or corroded contacts.
Check each pin and each socket of


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.