PIN AS-YM 3967276 - Caterpillar

Remove nut (9), solenoid (8), and stem (7) from manifold (4).
Remove O-rings (10) from stem (7).
Remove O-ring (6) from manifold (4).
Illustration 5 g00526471
Illustration 6 g00526472
Remove two dowels (11) and plate (12).
Illustration 7 g00526480
Remove O-ring (14) from valve (15).
Remove bolts (13) and remove valve (15).
Illustration 8 g00526481
Remove O-ring seal (16) from valve (15).
Remove bolts (17) and remove plate (18) from valve (15).
Illustration 9 g00526482
Illustration 10 g00526483
Remove four O-ring seals (19).
Remove two springs (20) and (21) from each bore.
Illustration 11 g00526484
Remove four pistons (22).
Illustration 12 g00526485
Remove four plugs (26) and seals (25).
Remove springs (24) and spools (23).
Illustration 13 g00526487
Illustration 14 g00526488
Remove plate (27) from manifold (28).
Remove dowels (30).
If necessary, remove plugs (29) from plate (27). Note: Plugs (29) are not interchangeable. Do not mix.
Illustration 15 g00526510
Illustration 16 g00526512
Remove O-ring seal (31) from manifold (28).
Remove nut (33), spacer (32), and solenoid (34).
Remove stem (35).
Remove O-ring seals (36) from the stem (35). Repeat this procedure for the remaining solenoid assemblies.
Illustration 17 g00526515
Illustration 18 g00526517
Illustration 19 g00526518
Remove two dowel pins (37) from manifold (28).
Install M16 × 2.0 Bolt (38) in spool assembly (39) and remove two spool assemblies.