PIN 4416616 - Caterpillar

Boom Line - Install
SMCS Code: 6301-012-L1
Do not use a wire rope cable that is kinked, frayed or has worn spots. Wear gloves when handling the wire rope cable.
Use 6 × 25 filler wire, right regular lay, independent wire rope core, pre-formed, improved plow steel-type cables. The wire cables should have a minimal breaking strength of 26 672 kg (58,800 lb).
1. Unroll the new boom winch cable from the spool. Weld the ends of the boom winch cable in order to prevent fraying.
Unroll all of the boom winch cable from the spool. Lay the cable on a flat surface. Never lift the cable off the spool in coils
2. Install the boom winch cable in the drum with clamp (8).3. Wind one half of the boom winch cable on the drum. Wind the cable evenly across the drum. 4. Install boom winch cable (7) in the upper block around sheave (1). Install boom winch cable (7) around sheave (1) from the front of the machine toward the rear of the machine.5. Install the cable around sheave assembly (3) in the lower block from the rear of the machine toward the front of the machine.6. Install the cable around sheave assembly (2) in the upper sheave block.7. Install the cable around sheave (4) in the lower sheave block.8. Insert the boom winch cable into the pocket and around wedge (5). Tap wedge (5) and the cable into the pocket with a mallet.9. Insert the end of the boom winch cable through clamp (6). Tighten the setscrew in the clamp to a torque of 45 7 N m (33 5 lb ft).10. Raise the boom.