AVSPARE.COM
parts catalog

PLATE AS 1246694 - Caterpillar



1246694 PLATE AS Caterpillar parts 65C, 75C, 75D, 85C, 85D PLATE
Rating:
25
Alternative (cross code) number:
CA1246694
124-6694
1246694
Caterpillar 1246694 PLATE AS
Weight: 7 pounds 3 kg.

Buy PLATE AS 1246694 Caterpillar genuine, new aftermarket tractor parts with delivery
CHALLENGER,

Compatible equipment models: 1246694:

CHALLENGER  65C   75C   75D   85C   85D   Caterpillar
Number on catalog scheme: 4
 
  For full view, you need register

Information:


Illustration 1 g01319898
Schematic of the Left Drive Motor SolenoidThis diagnostic code is associated with the implement pilot supply solenoid. The FMI 03 means that the ECM has detected that the voltage of the solenoid circuit is above normal or that the ECM has detected voltage in the circuit when no voltage should be present.Conditions that could causes this diagnostic code to be activated are:
The energize circuit of the solenoid is shorted to another voltage source.
The ECM has failed. This is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. System Response:The functionality is lost and the ECM cannot stop the motors. The machine will not be able to move.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector from the solenoid. Disconnect the machine harness connectors J1 and J2 from the ECM.
At the machine harness ECM connectors, measure the resistance from contact J1-58 (wire C955-BR) to all of the other contacts that are used in the J1 and J2 connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
YES - Each resistance measurement is greater than 5000 ohms. The resistance measurement does not indicate a short in the machine harness. Proceed to Test Step 2.
NO - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. Repair: The short is between wire G953-BU and the circuit that has a low resistance measurement.For information on testing for short circuits and finding short circuits, refer to Testing and Adjusting, "Wiring Harness (Short Circuit) - Test". Repair the machine harness or replace machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the machine harness connector J2 for the ECM, use a 151-6320 Removal Tool to remove the solenoid energize wire C955-BR and socket at contact J1-58 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 1707 FMI 03 diagnostic code.Expected Result:The CID 1707 FMI 03 diagnostic code is no longer active. A CID 1707 FMI 05 diagnostic code is now active.Results:
YES - The CID 1707 FMI 03 diagnostic code is no longer active. A CID 1707 FMI 05 diagnostic code

Caterpillar parts catalog:

Caterpillar parts catalog
Challenger 75C Agricultural Tractor 4KK01000-UP (MACHINE) POWERED BY 3176 Engine
Challenger 85C Agricultural Tractor 9TK01000-UP (MACHINE) POWERED BY 3176 Engine
Challenger 65D Agricultural Tractor 2ZJ01965-UP (MACHINE) POWERED BY 3306 Engine
Challenger 75D Agricultural Tractor 5AR00001-UP (MACHINE) POWERED BY 3176C Engine
Challenger 85D Agricultural Tractor 4GR00001-UP (MACHINE) POWERED BY 3196 Engine


Parts plate Caterpillar catalog:

1003652 PLATE-THRUST
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 235, 235B, 330, 3304, 3304B, 3306, 3306B, 3306C, 330B L, 350, 515, ...
7N7998 PLATE-BLOCK
12G, 12H, 12H ES, 12H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 235, 235B, 330, 330 L, 3306, 3306B, 3306C, 330B, 330B L, 350, 528B, 530B, 545, ...
8N4960 PLATE-THRUST
120B, 120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 225, 229, 235, 235B, 235C, 235D, 330, 330 L, 3304, 3304...
2P1738 PLATE AS-OIL PAN
120B, 12G, 12H, 12H ES, 12H NA, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 235B, 235C, 330, 330 FM L, 330 L, 3306, 3306B, 3306C, 330B, 330B L, 350, 5...
2D4202 PLATE
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12E, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 14H NA, 160G, 160H, 160H ES, 160H NA, 160K, ...
1105138 PLATE-THRUST
3176, 3176B, 75, 75C, 85C
9T2232 PLATE-WAFER
30/30, 428, 5130, 65C, 75C, 75D, 85C, 85D, 918F, 924F, 928F, 928G, 928H, 928HZ, AP-1000, AP-1000B, AP-1055B, AP-650B, AP-800C, AP-800D, AP-900B, BG-225B, BG-225C, BG-2455C, BG-245C, D4H, D4H XL, D4HTS...
9T3030 PLATE
416, 426, 436, 517, 527, 65C, 75C, 75D, 85C, 85D, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
6E6584 PLATE-SPACER
426, 517, 527, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
6E6585 PLATE-LIMITER
426, 517, 527, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
9T3019 PLATE
416, 426, 436, 517, 527, 65C, 75C, 75D, 85C, 85D, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
9T3860 PLATE
30/30, 428, 5130, 65C, 75C, 75D, 85C, 85D, 918F, 924F, 928G, 928H, 928HZ, 938F, 938G, 938G II, 988F, 988F II, AP-1000, AP-1000B, AP-1055B, AP-650B, AP-800C, AP-800D, AP-900B, BG-225B, BG-225C, BG-2455...
1214741 PLATE AS
75C, 75D, 85C, 85D
4E2404 PLATE
65C, 75C, 75D, 85C, 85D
1094031 PLATE-COVER
65C, 75C, 75D, 85C, 85D
1094163 PLATE
65C, 75C, 75D, 85C, 85D
1069925 PLATE
65C, 75, 75C, 75D, 85C, 85D
8E0401 PLATE-CLUTCH
14M, 16M, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E, TA19-M2WD, TA19-M4WD
7T3860 PLATE
65, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E
9W0339 PLATE
65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E
9W0338 PLATE-COVER
65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E
9U3194 PLATE AS
65C, 75C, 75D, 85C
9U3284 PLATE
65C, 75C, 75D, 85C
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.