AVSPARE.COM
parts catalog

PLATE, SUPPORT R.H. 77010078 - Caterpillar



77010078 PLATE, SUPPORT R.H. Caterpillar parts PS-110, PS-130, PS-180 PLATE
Rating:
39
Alternative (cross code) number:
CA77010078
7701-0078
77010078
Caterpillar 77010078 PLATE, SUPPORT R.H.

Buy PLATE, SUPPORT R.H. 77010078 Caterpillar genuine, new aftermarket tractor parts with delivery
PNEUMATIC COMPACTOR,

Compatible equipment models: 77010078:

PNEUMATIC COMPACTOR  PS-110   PS-130   PS-180   Caterpillar
Number on catalog scheme: 1
 
  For full view, you need register

Information:


Illustration 4 g01159881
Sensor connector
(A) +5 V supply
(B) Sensor return
(C) Signal
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connectors that are associated with the circuit.
Check the allen head screw for each ECM connector for the proper torque. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.
Check the harness and wiring for abrasion and for pinch points from the pressure sensors back to the ECM. Expected Result:All connectors, pins and sockets are completely coupled and/or inserted and the harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - The harness and connectors appear to be OK. Proceed to Test Step 2.
Not OK - There is a problem with the connectors and/or wiring.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Ensure that all of the seals are properly in place and ensure that the connectors are completely coupled.Verify that the repair eliminates the problem.STOPTest Step 2. Check the Supply Voltage at the Sensor Connector
Turn the keyswitch to the OFF position.
Disconnect the harness connectors for the following sensors:
Atmospheric pressure sensor
Boost pressure sensor
Engine oil pressure sensor
Fuel pressure sensor
Injection actuation pressure sensor
Turn the keyswitch to the ON position. Note: Be sure to wiggle the harness during the following measurements in order to reveal an intermittent condition.
Measure the voltage between terminals A and B at each sensor connector on the engine harness.
Turn the keyswitch to the OFF position.
Connect all of the sensors. Expected Result:Each voltage measurement is 5.0 0.2 VDC.Results:
OK - Each voltage measurement is 5.0 0.2 VDC. The voltage is correct at the sensor connectors. Proceed to Test Step 3.
Not OK - At least one voltage measurement is not 5.0 0.2 VDC.Repair: Refer to Troubleshooting, "5 Volt Engine Pressure Sensor Supply Circuit - Test".STOPTest Step 3. Check for Active Diagnostic Codes
Connect Caterpillar Electronic Technician (ET) to the service tool connector.
Turn the keyswitch to the ON position.
Observe the "Active Diagnostic" screen on Cat ET. Wait at least 45 seconds so that any codes may become active. Look

Caterpillar parts catalog:

Caterpillar parts catalog
PS-180 PNEUMATIC COMPACTOR 7PD00045-UP (MACHINE) POWERED BY 4.236 ENGINE
PS-110 PNEUMATIC COMPACTOR 7MD00051-UP (MACHINE) POWERED BY 4.236 ENGINE
PS-130 PNEUMATIC COMPACTOR 7ND00121-UP (MACHINE)
PS-130 PNEUMATIC COMPACTOR 7ND00001-00120 (MACHINE)
PS-180 PNEUMATIC COMPACTOR 7PD00001-00044 (MACHINE)


Parts plate Caterpillar catalog:

0676843 PLATE-REAR
206, 212, 416, 426, 428, 436, 438, PS-110
0676301 PLATE
206, 212, 214, 224, 3054, 3056, 312, 426B, AP-1200, CS-323, PS-110, PS-200B
5P9466 PLATE-WARNING
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, 30/30, 518, 528, 528B, 530B, 572R, 578, 583R, 589, 613B, 613C, 615, 615C, 69D, 768C, 769C, 772B, 773B, 776, 777, 777B, 814B, 815B, 816B, 824C, ...
8C0608 PLATE-CORPORATE SYMBOL
12G, 130G, 140G, 508, 621B, 916, 926, 936, 950B, 950B/950E, 966C, 966D, 980C, CB-414, CB-514, CB-534, CB-614, CP-433B, CS-551, D7H, D8L, D9N, E450, G936, IT18, IT18B, IT28B, PS-110, PS-180, RR-250
0691179 PLATE
AP-800, PS-110
7C4631 PLATE
CS-323, PS-110
59000137 PLATE, SPACER
CB-414, CB-514, CB-614, CS-431, CS-433, PS-110, PS-130, PS-180
A073801 PLATE, RETAINER
PS-110, PS-130, PS-180
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.