AVSPARE.COM
parts catalog

PLATE A 9W0200 - Caterpillar



9W0200 PLATE A Caterpillar parts PLATE
Rating:
16
Alternative (cross code) number:
CA9W0200
9W-0200
9W0200
Caterpillar 9W0200 PLATE A

Buy PLATE A 9W0200 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

3. Remove the bolts that hold trunnion (2) to the frame of the vehicle.4. Fasten a hoist to the engine and lift it enough to remove the weight from trunnion (2). Put blocks under the engine block to hold the front of the engine up, and remove the hoist. The total weight of the engine is 7430 kg (16,400 lb).5. Remove three of bolts (1), and install three 1/2" - 13 NC guide bolts (3). Remove the remainder of bolts (1) from the trunnion. 6. Pull trunnion (2) away from the front drive housing enough to fasten a hoist as shown. Remove trunnion (2) from the engine. The weight of trunnion (2) is 54 kg (119 lb). 7. Remove the bolts to remove mount assembly (4) from trunnion (2) if necessary. The weight of mount assembly (4) is 20 kg (44 lb). The following steps are for installation of the trunnion.8. Put mount assembly (4) in position, and install the bolts to hold it to trunnion (2). Tighten the bolts to a torque of 200 20 N m (150 15 lbft).9. Install three 1/2" - 13 NC guide bolts (3) in the front drive housing. Fasten a hoist to trunnion (2), and put it in position on the guide bolts. Remove the hoist, and install 27 of bolts (1) to hold trunnion (2) in position. Remove the guide bolts, and install the remainder of bolts (1). Tighten all of bolts (1) to a torque of 135 15 N m (100 11 lbft).10. Fasten a hoist to the front of the engine, and lift it to remove the blocks under it. Lower the engine until trunnion (2) is against the frame of the vehicle. Remove the hoist, and install the bolts that hold the trunnion and engine in position. Tighten the bolts to a torque of 475 50 N m (350 37 lbft).11. Connect the water pump inlet to the radiator, and fill the cooling system with coolant to the correct level. See the Maintenance Manual.End By:a. install crankshaft pulley and vibration damperb. install oil pan


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.