AVSPARE.COM
parts catalog

PLATE-COVER 9W0338 - Caterpillar



9W0338 PLATE-COVER Caterpillar parts 65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E PLATE
Rating:
11
Alternative (cross code) number:
CA9W0338
9W-0338
9W0338
Caterpillar 9W0338 PLATE-COVER
Weight: 2 pounds 1 kg.

Buy PLATE-COVER 9W0338 Caterpillar genuine, new aftermarket tractor parts with delivery
CHALLENGER,

Compatible equipment models: 9W0338:

CHALLENGER  65   65C   65E   75C   75D   75E   85C   85D   85E   95E   Caterpillar
Number on catalog scheme: 2
 
  For full view, you need register

Information:


Illustration 1 g01323956
Schematic of the Travel Pressure SensorThis diagnostic code is associated with the Travel Pressure Sensor. This is an analog sensor which produces a voltage to the ECM on pin J1-37 (wire J785-PU). This diagnostic code is active when the machine ECM detects a voltage on the signal wire that is less than 0.2 volts. The possible causes of this failure are listed here:
The sensor has failed.
There is an open in the supply wire.
The signal circuit in the machine harness is shorted to ground.
The machine ECM has failed. Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.System Response:A level 1 warning will be generated. The ECM will set the drive loop pressure reading to 0 kPa (0 psi).Test Step 1. CHECK THE VOLTAGE AT THE SENSOR.
Turn the disconnect switch and the key start switch to the ON position.
Disconnect the sensor from the machine harness.
At the machine harness connector for the sensor, measure the voltage between supply contact 1 (wire J844-GY) and return contact 2 (wire J764-BRExpected Result:The voltage is 5 0.3 DCV.Results:
OK - The voltage is 5 0.3 DCV. Proceed to Test Step 2.
NOT OK - The voltage is NOT 5 0.3 DCV.Repair: There is an open in the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE SENSOR.
Disconnect the machine harness from the sensor. Expected Result:The diagnostic code changes from CID 0148 FMI 04 to CID 0148 FMI 03. Results:
OK - The diagnostic code changed to CID 0148 FMI 03. This indicates that the failure is no longer present. The sensor has failed.Repair: Replace the sensor.STOP
NOT OK - The diagnostic code CID 0148 FMI 04 remained active. This indicates that the failure remains present. The sensor is not causing the failure. Proceed to test step 3.Test Step 3. CHECK THE HARNESS.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the J1 machine harness connector from the ECM.
At the J1 machine harness connectors for the ECM, measure the resistance from the signal contact of the sensor J1-37 (wire R785-PU) to all other J1 contacts. Expected Result:The resistance is greater than 5000 ohms. Results:
OK - The resistance is greater than 5000 ohms. The harness circuit resistance is correct. The machine ECM may have failed. Repair: If the cause of the problem is not found, contact the Technical Communicator for your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the ECM requires replacement, see Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance is less than 5000 ohms. The machine harness has failed. There is a short between frame ground and the signal circuit in the

Caterpillar parts catalog:

Caterpillar parts catalog
Challenger 75C Agricultural Tractor 4KK01000-UP (MACHINE) POWERED BY 3176 Engine
Challenger 85C Agricultural Tractor 9TK01000-UP (MACHINE) POWERED BY 3176 Engine
Challenger 65D Agricultural Tractor 2ZJ01965-UP (MACHINE) POWERED BY 3306 Engine
Challenger 75D Agricultural Tractor 5AR00001-UP (MACHINE) POWERED BY 3176C Engine
Challenger 85D Agricultural Tractor 4GR00001-UP (MACHINE) POWERED BY 3196 Engine
Challenger 95E Agricultural Tractor 6KS00001-UP (MACHINE) POWERED BY 3196 Engine
Challenger 85E Agricultural Tractor 6JS00001-UP (MACHINE) POWERED BY 3196 Engine
Challenger 75E Agricultural Tractor 6HS00001-UP (MACHINE) POWERED BY 3176C Engine
Challenger 65E Agricultural Tractor 6GS00001-UP (MACHINE) POWERED BY 3176C Engine
Challenger 65E Agricultural Tractor 1GM00001-UP (MACHINE) POWERED BY 3176 Engine
Challenger 75E Agricultural Tractor 1HM00001-UP (MACHINE) POWERED BY 3176 Engine
Challenger 85E Agricultural Tractor 1NM00001-UP (MACHINE) POWERED BY 3196 Engine
Challenger 95E Agricultural Tractor 1SM00001-UP (MACHINE) POWERED BY 3196 Engine


Parts plate Caterpillar catalog:

1003652 PLATE-THRUST
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 235, 235B, 330, 3304, 3304B, 3306, 3306B, 3306C, 330B L, 350, 515, ...
9Y7524 PLATE
12G, 12H, 12H ES, 12H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 235B, 235D, 330, 330 L, 3306, 3306B, 3306C, 330B, 330B L, 3412, 350, 528B, 530B, 545, ...
1P6356 PLATE
1090, 1190, 1190T, 120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 1290T, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 130G, 135H, 135H NA, 1390, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 143H, 14G, ...
1105138 PLATE-THRUST
3176, 3176B, 75, 75C, 85C
8P1656 PLATE-CLUTCH
120G, 12G, 130G, 140G, 14G, 14H, 14H NA, 160G, 16G, 16H, 16H NA, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E
9T2232 PLATE-WAFER
30/30, 428, 5130, 65C, 75C, 75D, 85C, 85D, 918F, 924F, 928F, 928G, 928H, 928HZ, AP-1000, AP-1000B, AP-1055B, AP-650B, AP-800C, AP-800D, AP-900B, BG-225B, BG-225C, BG-2455C, BG-245C, D4H, D4H XL, D4HTS...
6E6584 PLATE-SPACER
426, 517, 527, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
6E6585 PLATE-LIMITER
426, 517, 527, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, AP-1000B, AP-1055B, AP-650B, BG-225C, BG-2455C, BG-245C, D5H, D5H XL, D5HTSK II, D6M
9T3860 PLATE
30/30, 428, 5130, 65C, 75C, 75D, 85C, 85D, 918F, 924F, 928G, 928H, 928HZ, 938F, 938G, 938G II, 988F, 988F II, AP-1000, AP-1000B, AP-1055B, AP-650B, AP-800C, AP-800D, AP-900B, BG-225B, BG-225C, BG-2455...
3P0335 PLATE-CLUTCH PRESSURE
120G, 12G, 130G, 140G, 160G, 65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E
2463144 PLATE-THRUST
140H, 143H, 14H, 14M, 160H, 163H, 16H, 16M, 3176C, 3196, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L HVG, 349E L VG, 349F L, 3...
1348361 PLATE-CLUTCH
725, 725C, 730, 730C, 735, 85E, 95E, C9, CX31, CX31-C13I, CX31-C15I, CX31-C18I, CX31-C9I, CX31-P600, CX35, CX35-C18I, CX35-P800, TA19-M2WD, TA22-M4WD, TH31-E61, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C...
9U3194 PLATE AS
65C, 75C, 75D, 85C
9U3284 PLATE
65C, 75C, 75D, 85C
1246694 PLATE AS
65C, 75C, 75D, 85C, 85D
1214741 PLATE AS
75C, 75D, 85C, 85D
4E2404 PLATE
65C, 75C, 75D, 85C, 85D
7T7115 PLATE
65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E
8R9786 PLATE
65, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E
3W6166 PLATE
65, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E
8E0401 PLATE-CLUTCH
14M, 16M, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E, TA19-M2WD, TA19-M4WD
7T3860 PLATE
65, 65C, 65E, 75, 75C, 75D, 75E, 85C, 85D, 85E, 95E
9W0339 PLATE
65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.