AVSPARE.COM
parts catalog

PLATES, THRUST 70000276 - Caterpillar



70000276 PLATES, THRUST Caterpillar parts CB-414, CB-514 PLATES
Rating:
46
Alternative (cross code) number:
CA70000276
7000-0276
70000276
Caterpillar 70000276 PLATES, THRUST

Buy PLATES, THRUST 70000276 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 70000276:

VIBRATORY COMPACTOR  CB-414   CB-514   Caterpillar
Number on catalog scheme: 13
 
  For full view, you need register

Information:

Connection Procedure
Table 1
Required Tools    
Item    Qty    Part Number    Description    
A     2     180-3034     Stand Gp (10 Ton)    
B     1     136-1452     Retaining Ring Pliers As    
G     1     4C-5593     Anti-Seize Compound    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in a cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. All disassembly and assembly procedures must be performed in a clean work area.Note: The pin bores of the track links should be toward the front idler.
Attach a suitable lifting device to the track. Wrap the track onto the drive sprocket. Make sure that the track assembly is past the vertical center line of the drive sprocket.
Illustration 1 g01049372
Place Tooling (A) under a track segment (1) at the sprocket end of the track roller frame.
You must pull the cable in a straight line.
Attach a suitable lifting device to the track assembly. Raise the track assembly onto the front idler. Use a wheel loader or a suitable machine in order to carry the track assembly over the track carrier rollers until the track assembly reaches the other end of the track assembly.
Place Tooling (A) in position under the track shoe at the front idler end of the track assembly.
Apply Tooling (G) in the pin bores of the track links.
Illustration 2 g01049374
Connect the ends of the track assembly. Align the pin bores in both links. Coat the pins with Tooling (G). Drive pins (4) into place.
Install plate (3) outside of both pins (4) .
Use Tooling (B) (not shown) to install retaining ring (2) outside of both plates (3) .Note: The machine will automatically tension the track when the machine is started.

Caterpillar parts catalog:

Caterpillar parts catalog
CB-514 VIBRATORY COMPACTOR 6YD00001-UP (MACHINE) POWERED BY 3.53 ENGINE
CB-414 VIBRATORY COMPACTOR 6KD00001-UP (MACHINE) POWERED BY 4239D ENGINE


Parts plates Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.